Need picture of ICV / knock sensor to block mounting
06-21-2011, 02:41 AM
#16
Rennlist Member
Sorry, haven't had a chance to look. For originality pictures, I will only have old pics of my original motor. Crazy Eddie just went through sorting the line/harness routing for originality and has some good pictures. I'll ping him to see if he has some to share too.
06-21-2011, 03:39 AM
#17
Rennlist Member
Tom, any luck with a few more pics? That pic of the heat shields helped, and I've found a few more pics ov various motor projects while searching the forum, but I would still like to see more if you have any that you don't mind sharing. Mostly looking for wiring/line routing under the intake manifold and along the firewall. Thanks!!
I have the firewall wires completed now, so if you want I can shoot some tomorrow for you ... These shots are with the wires not completely hooked up yet...
Email me if you want higher resolution pictures ?
I can also send or post some dismantling pictures ( as I was tearing things down )
Hope that helps
Regards
Ed
06-21-2011, 04:05 AM
#18
Rennlist Member
Here are some old ones ( tear down )
Here are a few more pictures
Hope it helps
Regards
Ed
Hope it helps
Regards
Ed
06-21-2011, 08:42 PM
#20
Rennlist Member
