Finally finished cleaning the engine bay
10-10-2010, 02:56 PM
#79
Rennlist Member
Looks Awesome !! Great pictures
So you 86'ed the x over coolant bar ?
Best of luck
Ed
So you 86'ed the x over coolant bar ?
Best of luck
Ed
10-10-2010, 10:45 PM
#82
Drifting
Thread Starter
Yep it's kinked. I am going to get a new hose made up by greenline fittings. It's a little tight with the larger pulley.
Last edited by gruhsy; 04-01-2020 at 05:49 PM.
10-11-2010, 08:32 AM
#89
Addict
Rennlist Member
Rennlist Small
Business Sponsor
Rennlist Member
Rennlist Small
Business Sponsor
A couple of notes –
The lower radiator hose needs to be trimmed shorter by about 1” to make up for the extra thickness of the radiator – it will sit better that way.
The oil line is supposed to go on the outside of the lower radiator hose – that way it will not kink.
When you add the Evans coolant make sure you don’t spill or leak any on the engine – the free air boiling point is so high that it will never boil or evaporate – and you will smell hot coolant forever!
Looks pretty nice!
The lower radiator hose needs to be trimmed shorter by about 1” to make up for the extra thickness of the radiator – it will sit better that way.
The oil line is supposed to go on the outside of the lower radiator hose – that way it will not kink.
When you add the Evans coolant make sure you don’t spill or leak any on the engine – the free air boiling point is so high that it will never boil or evaporate – and you will smell hot coolant forever!
Looks pretty nice!
10-11-2010, 08:36 AM
#90
Im not sure if this has been asked yet but, where are you going to install the flux capacitor?
Good looking build! What type of numbers you hoping to see on the dyno?
Good looking build! What type of numbers you hoping to see on the dyno?