TheDice951

I am currently putting my car back together and I have the one quick connect elbow on the head and am wondering where other members have put the other end at.... I have a new expansion tank and was wondering if I could tap it to the tank or does it have to be routed in the lines somewhere.... I would like pictures of the other end of the vent tube set-up.... I searched and couldn’t find what I was looking for.... your help would be appreciated

Techno Duck

How i did mine,

TheDice951

thank you... i like that....


anyone else?

minho78

Same place as Jon shows in the pic.

APKhaos

That's the location that Lindsey specifies in the kit install instructions. Why do anything different?

PorscheDude1

Mine is also like the picture.

RobE952

mine too. Except I seeem to remember it being a little higher up.

TheDice951

thanks guys.... i didnt get any instructions with anything i ordered.... unless they have instructions on the site i didnt see... if they do where is it?

rlm328

here is the link to the steam vent install.

http://www.lindseyracing.com/LR/Parts/TECHSTEAM.html

Question is where did you drill the head if you didn't have any instructions.

APKhaos

Hmmm.......good question!

TheDice951

haha.... i got that info from here.... i just couldnt find a good picture of the other end.... i kinda wanted to tap directly in the expantion tank for a clean look..... less chance for leaks

Acetylene

Mine is in the same spot - no leaks three years later