About to build an engine - I could use some advice
#61
RL Community Team
Rennlist Member
Rennlist Member
Thread Starter
Thanks Chris, that's very helpful.
I've always wondered: when one takes a flywheel in to get resurfaced, do they balance it too or do they simply shave it and hand it back (typically speaking)?
I've always wondered: when one takes a flywheel in to get resurfaced, do they balance it too or do they simply shave it and hand it back (typically speaking)?
#62
Addict
Rennlist Member
Rennlist Small
Business Sponsor
Rennlist Member
Rennlist Small
Business Sponsor
If not specificed they will not balance it. Also - the 951 flywheel is a little different than 'typical' flywheels - they need to resurface it right out to the lip - most flywheel do not have a lip that locates the pressureplete. If they do not have a stone that is in good shape with a sharp edge they won't do a good job.