8 hours into the clutch job and....
#18
Instructor
Join Date: Jun 2006
Location: Southern Maryland
Posts: 107
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
I had the same problem too, engine out and everything. Eventually just drilled off the bolt heads and pulled the PP and clutch off then took off the flywheel and gave it to a machine shop, lol.
#19
Burning Brakes
Thread Starter
Join Date: Oct 2007
Location: Blacksburg, VA
Posts: 891
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
Yeah I'm gonna weld a flange onto the part that y's off to tie into the waste gate. That was the next time the bellhousing has to come off, i simply unbolt the flange and that piece that goes to the wastegate is out of my damn way. Much much easier than removing the damn crossover completely. And why would I want the rocks seconds?
#20
Lazer Beam Shooter
Rennlist Member
Rennlist Member
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
Yeah I'm gonna weld a flange onto the part that y's off to tie into the waste gate. That was the next time the bellhousing has to come off, i simply unbolt the flange and that piece that goes to the wastegate is out of my damn way. Much much easier than removing the damn crossover completely. And why would I want the rocks seconds?
![Smilie](https://rennlist.com/forums/images/smilies/smile.gif)
#21
Burning Brakes
Thread Starter
Join Date: Oct 2007
Location: Blacksburg, VA
Posts: 891
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
Haha, well should my supply of wonderful virginia tech girls ever begin to run out I will definitely take you up on your generous sharing offer. Done 18-20 hours of work at this point and all that's left is to put the transaxle back in and the exhaust back on. The end is in sight and damn the light at the end of the tunnel looks amazing! I did almost put the bell housing back together without putting the starter ring on the new pressure plate tho! Oops... luckily I caught that but only after I had torqued down the pressure plate.