Pics of Lemans rear spoiler please!
#1
Rennlist Member
Thread Starter
Pics of Lemans rear spoiler please!
The only car I have seen with it is horsepowerfarms car. Does anyone else have it? Any pictures? Im considering putting one on my car. Thanks.
Jeff
Jeff
#2
Addict
Rennlist Member
Rennlist Member
be prepared for cussing, drilling, filler, sand and paint. Lots of beer - but that's just what the PO of the hatch on the track car said. We were lucky, got the whole thing.
#3
Rennlist Member
You did say Lemons didn't you? That sure is some spoiler....
#5
Ditto what Ski says, the fit was off by a mile. Way to much work went into getting it to fit, but once it does it's a nice piece...
https://picproofs.net/tbranoff/nymet...c_2528.Jpg.php
https://picproofs.net/tbranoff/nymet...c_3573.Jpg.php
https://picproofs.net/tbranoff/nymet...c_2528.Jpg.php
https://picproofs.net/tbranoff/nymet...c_3573.Jpg.php
#7
Nordschleife Master
I think there are two different versions of this spoiler around. One is from the 924CGT, its basically a enlarged version of the stock 944 spoiler.
Im not sure what car the other type (which Wormhole and Ski have) is from. I would guess a LeMans 924 or 944.
Im not sure what car the other type (which Wormhole and Ski have) is from. I would guess a LeMans 924 or 944.
Trending Topics
#8
Rennlist Member
Thread Starter
Thanks for the pics guys. Im still on the fence. Im just not sure that the car is badass enough to rock this spoiler. I might have to see it in person before jumping into this project.
#10
Rennlist Member
Techno d , what is the one on the lower of the red cars pictured? Plus is that a wide body kit, it looks like it and not bad from the pics shown. The top one looks like it would hold lots of water unless it's got good drainage.
#12
Rennlist Member
When you guys say how much of a hassle it is to fit, is it something a body shop could/would do? Dumb question but I assume it still only attaches to the hatch itself? Being so, why is it such a pain to fit? Can we assume it was made for a different sized hatch? Should fit a 968 one yes?
#13
Addict
Rennlist Member
Rennlist Member
all the mounting holes are off, none match. I have no idea what :template: he used but you have to mark the holes as is sits on the hatch, drill them, and then finish to your level of expectation - fill, sand, paint if you want perfection.
#14
Race Car
Join Date: May 2005
Location: Being censored by a Moderator
Posts: 4,074
Likes: 0
Received 1 Like
on
1 Post
Just like the boxed flares the molds were taken from 924 cars and the like each to their own level of customization from Holbert. As I understand it, GT got most of his 924/944/951 line up from holbert's molds.
#15
Rennlist Member
Thanks guys. Still intriguing.