Notices
928 Forum 1978-1995
Sponsored by:
Sponsored by: 928 Specialists

The official 1979 Euro save thread

Thread Tools
 
Search this Thread
 
Old 07-19-2020, 08:46 PM
  #166  
AirtekHVAC
Rennlist Member
Thread Starter
 
AirtekHVAC's Avatar
 
Join Date: Mar 2012
Location: China Grove, NC
Posts: 3,563
Received 299 Likes on 181 Posts
Default

Thank you sir
Old 07-23-2020, 02:54 PM
  #167  
Callum_GT
Advanced
 
Callum_GT's Avatar
 
Join Date: May 2015
Location: Camberley, UK
Posts: 67
Received 2 Likes on 2 Posts
Default

Wow that is looking good
The following users liked this post:
AirtekHVAC (07-24-2020)
Old 07-27-2020, 12:16 PM
  #168  
AirtekHVAC
Rennlist Member
Thread Starter
 
AirtekHVAC's Avatar
 
Join Date: Mar 2012
Location: China Grove, NC
Posts: 3,563
Received 299 Likes on 181 Posts
Default

Parts waiting for re-assembly day, and refurbed cluster mounted in refurbed pod!




The following 3 users liked this post by AirtekHVAC:
Callum_GT (07-29-2020), drooman (04-01-2021), Harvey928 (07-27-2020)
Old 02-13-2021, 06:27 PM
  #169  
AirtekHVAC
Rennlist Member
Thread Starter
 
AirtekHVAC's Avatar
 
Join Date: Mar 2012
Location: China Grove, NC
Posts: 3,563
Received 299 Likes on 181 Posts
Default

Been doing a lot of little stuff...I continue to add to the stereo system, and decided to go with a different alpine than I had previously...like the look of this one a bit more...






Old 02-13-2021, 06:34 PM
  #170  
AirtekHVAC
Rennlist Member
Thread Starter
 
AirtekHVAC's Avatar
 
Join Date: Mar 2012
Location: China Grove, NC
Posts: 3,563
Received 299 Likes on 181 Posts
Default

Also installed the shark fin antennae to cover the hole made by the PO...








The following users liked this post:
Harvey928 (02-16-2021)
Old 02-15-2021, 10:53 AM
  #171  
linderpat
Rennlist Member
 
linderpat's Avatar
 
Join Date: Nov 2006
Location: Pittsburgh, PA
Posts: 14,451
Received 2,334 Likes on 1,279 Posts
Default

Ron that dash and pod is amazing work. You have a second calling I think! How well do you think it'll hold up over time?
Old 03-14-2021, 04:32 PM
  #172  
AirtekHVAC
Rennlist Member
Thread Starter
 
AirtekHVAC's Avatar
 
Join Date: Mar 2012
Location: China Grove, NC
Posts: 3,563
Received 299 Likes on 181 Posts
Default

I am hoping they hold up for years. My only baseline I have is that bondo and bondo-glass are used on car bodies that take more of a beating than this dash ever will, and, if done properly, seems to keep holding up, so fingers are crossed!

I have been sick the last week, and had almost no energy. I did muster a little today and get my power distribution block mounted and wired, as well as the ground block. I cleaned the passenger floorboard, which now has just speaker wires and antennae cable laying on it.

I then moved over to the drivers side, grinding out the pin and removing the ignition key cylinder which is bad, and severely worn out. Did the same to the parts car, who has a perfect key cylinder. Only drawback is now I will have (3) keys for this car...

not too far from installing the dash back in now!



Power feed for amp, stereo, HD module, and Bluetooth Module. Each item has its own inline fuse.

Master ground block. It is fed from (2) different chassis ground points. I will tie all audio grounds here.

Overview

Worn boss in 79 key cylinder

Not worn boss, key cylinder from 84 parts car
The following users liked this post:
Harvey928 (03-15-2021)
Old 03-21-2021, 08:42 PM
  #173  
AirtekHVAC
Rennlist Member
Thread Starter
 
AirtekHVAC's Avatar
 
Join Date: Mar 2012
Location: China Grove, NC
Posts: 3,563
Received 299 Likes on 181 Posts
Default

Finally had some time to mess with the euro a little bit. Replaced the ignition cylinder and now have her starting with a key instead of a screwdriver. Found that the passenger defroster vent was warped, replaced with a good one from my 84 parts car. Then got her up on the lift. Found many issues:
power steering rack is leaking badly
power steering hoses are leaking
AC hoses have been spliced- no bueno
fluid dripping from clutch slave and bell housing
exhaust pipe is broken
pumpkin has a crack in it

annnnd, who knows what else?

I will continue with the interior for now, then move to mechanicals.











Old 03-30-2021, 09:42 PM
  #174  
AirtekHVAC
Rennlist Member
Thread Starter
 
AirtekHVAC's Avatar
 
Join Date: Mar 2012
Location: China Grove, NC
Posts: 3,563
Received 299 Likes on 181 Posts
Default

Well, was going to start reassembly of the interior, starting with the dash, but something told me to test all the vacuum pods. Found that (3) would not hold vacuum. Replaced one. Need to find a couple more....always delays...sheesh
The following users liked this post:
Harvey928 (03-31-2021)
Old 09-17-2021, 12:15 AM
  #175  
AirtekHVAC
Rennlist Member
Thread Starter
 
AirtekHVAC's Avatar
 
Join Date: Mar 2012
Location: China Grove, NC
Posts: 3,563
Received 299 Likes on 181 Posts
Default

Been a while. No major work done as of late. Repaired/replaced all effed up vacuum pods. Last thing left before interior reassembly is refurb/repair the sunroof.

Also found a nasty little fuel leak in the rear…



The following users liked this post:
Harvey928 (09-17-2021)
Old 09-17-2021, 12:20 PM
  #176  
Harvey928
Burning Brakes
 
Harvey928's Avatar
 
Join Date: Feb 2011
Location: Cottonwood SD
Posts: 787
Received 284 Likes on 155 Posts
Default

that might be a fuel accumulator issue. Had one in my 79 recently and replaced the fuel accumulator and it solved the issue. My gas was coming from just in front of the rear wheel.
Old 09-19-2021, 05:41 PM
  #177  
AirtekHVAC
Rennlist Member
Thread Starter
 
AirtekHVAC's Avatar
 
Join Date: Mar 2012
Location: China Grove, NC
Posts: 3,563
Received 299 Likes on 181 Posts
Default

That’s what I suspect as well. I have a couple spares so all good. Not gonna worry about it until I complete the interior.
The following users liked this post:
Harvey928 (09-19-2021)
Old 05-23-2022, 06:02 PM
  #178  
AirtekHVAC
Rennlist Member
Thread Starter
 
AirtekHVAC's Avatar
 
Join Date: Mar 2012
Location: China Grove, NC
Posts: 3,563
Received 299 Likes on 181 Posts
Default

Project stalled slightly, but not forgotten, she’s still running

The following users liked this post:
WestInc (05-23-2022)



Quick Reply: The official 1979 Euro save thread



All times are GMT -3. The time now is 07:35 AM.