When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I hope to attend and will be bringing a Becker CDR 220 however the volume control is stuck on 4 (scale 1-10).
I sent the unit out(Feb/17) to SW Stereo Specialist (Stephan) for no sound and the shipping from Canada to and from was approx. $55 US. I will move on to another unit instead of paying for shipping charges. Perhaps much less expensive from US destination.
If interested send me a message.
Unfortunately, I'm out. Received a call from the alignment shop (which also happens to be a collision repair facility). They stated the cannot do an alignment because something where the lower control arms connect to the frame is bent.
I remember seeing this before taking it in. The big bolts that attached the lower control arm to the frame look like the are crooked back about 1/4 inch. I wish I had a picture and will start a new thread when I do. I thought it looked odd, but there is approximately the same "offset" on both sides so I figured it was ok.
I've got new rubber waiting to be installed at Discount tire today. However, unless I get a second opinion and a alignment shop willing to alignment as is, I may be not be ready to roll tomorrow.
update: alternative alignment shop is book till next week.
Last edited by auzivision; 06-01-2017 at 09:34 AM.
Not looking good, just received a call from the alignment shop (which also happens to be a collision repair facility). They stated the cannot do an alignment because something where the lower control arms connect to the frame is bent.
I remember seeing this before taking it in. The big bolts that attached the lower control arm to the frame look like the are crooked back about 1/4 inch. I wish I had a picture and will start a new thread when I do. I thought it looked odd, but there is approximately the same "offset" on both sides so I figured it was ok.
I've got new rubber waiting to be installed at Discount tire today. However, unless I get a second opinion and a alignment shop willing to alignment as is, I may be not be ready to roll tomorrow.
Fingers crossed for you Kurt. Won't be the same without you.
Mine is out for an alignment today as well. New rack, tie rods and indeterminate shaft donut.
Last edited by Adamant1971; 05-31-2017 at 11:34 AM.
I have a spare engine service yolk which I can bring if anyone is interested in it. I figure I wont ever need three. Its a bit big to bring unless someone needs one.
05-29-2017, 11:15 PM
