When I replaced my fuel injectors there were numerous plugs without the wire clip on the plug.
Anyone know where I can get replacements?

Looked online and can't find just the clips

 

Possibly Roger , I was thinking I bought a few during my top end rebuild.

 

EaagleDay carries them.

Mike

 

You can go to the local junkyard and pull a few. They are the same for all injectors of the same type.

 

Yes we have them in stock - 2 way spring clips

 

Need 6
Yes 6vwere missing..m..

 

where did you find instructions on the fuel inject replacement procedures? I am looking to do this over the winter.

 

I'm pleased to report I drove my car to a local Cars & Coffee event on Saturday, and I put about 50 miles on it without issue. My car now starts easily, idles very smoothly, and no longer smells rich when idling. Both the performance and gas mileage improved, however, now my focus needs to be on getting the transmission working properly by troubleshooting whether there is a vacuum leak (highly likely) and whether the modulator needs to be replaced. Stay tuned!

For now, I posted a video on my YouTube that attempted to cover everything that happened on this thread throughout April:
In that 38 minutes, I cover the following:
1. Fuel Injector wiring repinning and connector replacement
2. Crankshaft Position Sensor replacement
3. Throttle Position Sensor Cable replacement
4. Fuel Injector testing with a 9V battery
5. Amplifier Replacement

In this earlier video, I document the procedure I used to remove the fuel injectors from my S3 32V. Installation is the reverse of what is shown in this video:

 

Rudy, you are a champ! Looking good.
Cheers

 

You should read my last post in this thread about Ignition Modules
https://rennlist.com/forums/928-foru...condition.html
I would rather use, used ones from DCauto.com or from Mark Anderson than anything new right now. I don't know about the Porsche ones but they are 200+ bucks.