SF Bay Area S4 Part Out
#1
SF Bay Area S4 Part Out
My 88 S4 is in sorts..bad engine out, new engine not prepped for install, so not in car.
Im pretty sure I can get more parting, than selling as a whole car, considering additional time and expense.
First up:
A28.16 LSD Transmission W/TT complete. This is the '89 2.54 LSD with special trans gearing as well. It's a kick in the pants. Put a SC in front of this and wake the Gods.
-This was installed with a rebuilt TT from Mark Anderson, with new TQ Conv bearings and seals by Ole Jorgensen in Orange, CA on 12/19/2011.
$2500+ship
Second:
87 long block, 60k miles. Purchased from 928intl 20mos ago, comes with a SUPERB condition harness as well, butter soft. The #6 rod cap was removed to check bearing condition...so you will need two new nuts for that. Bearings are good! Has been in my garage complete and dry...give it an intake refresh and it'll run.
$3000+ship
Third:
12-way heated seats. And they work. Cancan Red, but were dyed at some point. Excellent frames, good padding, drivers bolster panel ripped. They will come with the can-can red door panel inserts, rear seat pads, and rear AC cover.
$800+ship
You will be responsible for shipping.
Engine comes from my residential home (95006)..other parts come from a business location (an airport 95148)
I greatly recommend uship.com
Mods: Kindly keep this thread here..I will be gathering photos tomorrow before work, and then in the afternoon at the airport, then I will update the thread..once you see photos, you can move it.
Im pretty sure I can get more parting, than selling as a whole car, considering additional time and expense.
First up:
A28.16 LSD Transmission W/TT complete. This is the '89 2.54 LSD with special trans gearing as well. It's a kick in the pants. Put a SC in front of this and wake the Gods.
-This was installed with a rebuilt TT from Mark Anderson, with new TQ Conv bearings and seals by Ole Jorgensen in Orange, CA on 12/19/2011.
$2500+ship
Second:
87 long block, 60k miles. Purchased from 928intl 20mos ago, comes with a SUPERB condition harness as well, butter soft. The #6 rod cap was removed to check bearing condition...so you will need two new nuts for that. Bearings are good! Has been in my garage complete and dry...give it an intake refresh and it'll run.
$3000+ship
Third:
12-way heated seats. And they work. Cancan Red, but were dyed at some point. Excellent frames, good padding, drivers bolster panel ripped. They will come with the can-can red door panel inserts, rear seat pads, and rear AC cover.
$800+ship
You will be responsible for shipping.
Engine comes from my residential home (95006)..other parts come from a business location (an airport 95148)
I greatly recommend uship.com
Mods: Kindly keep this thread here..I will be gathering photos tomorrow before work, and then in the afternoon at the airport, then I will update the thread..once you see photos, you can move it.
#5
#6
Wife unit was -very- clear on the -1- car rule.
Will have photos late this afternoon when I get to airport.
#7
Trending Topics
#15
Needed a new motor, and while waiting to finish the new motor in my garage, a deal I couldnt pass up came along, and I'm only allowed -1- project at a time.