Need Engine head-block dowels
#1
Rennlist Member
Thread Starter
Need Engine head-block dowels
I need to replace all the pins and dowels that are pressed into the block deck. I had them removed for when I had the block decked for the rat motor, but I do not know what size they are or if I have to be careful about replacing them with basic dowels and pins.
#2
Archive Gatekeeper
Rennlist Member
Rennlist Member
All available from Porsche (AFAIK) and cheap cheap cheap.
2 900 012 070 00 DOWEL PIN - 12x18- block to bellhousing 0.32
2 900 095 072 01 TENSION SLEEVE - 6 x 12 in block on rear of head surface 0.20
1 928 101 195 03 DOWEL PIN/FITTING BUSHING - Block to Girdle 3.76
2 N 013 199 1 DOWEL PIN - straight 6x12 waterpump pin(s)? 0.82
1 N 013 315 1 ROLL PIN 5 x 10 0.31
4 999.012.034.00 DOWEL PIN 3.76
2 900 012 070 00 DOWEL PIN - 12x18- block to bellhousing 0.32
2 900 095 072 01 TENSION SLEEVE - 6 x 12 in block on rear of head surface 0.20
1 928 101 195 03 DOWEL PIN/FITTING BUSHING - Block to Girdle 3.76
2 N 013 199 1 DOWEL PIN - straight 6x12 waterpump pin(s)? 0.82
1 N 013 315 1 ROLL PIN 5 x 10 0.31
4 999.012.034.00 DOWEL PIN 3.76
#3
Rennlist Member
Thread Starter
Thanks Rob.
How are the heads doing? We are sort of on the same stage right now - the lapping paste should be here tomorrow for me. Then I can start on smoothing the ports and bit and start assembly. I got a digital spring tester from Proform. Hope to get it this week. Bottom end is already assembled.
How are the heads doing? We are sort of on the same stage right now - the lapping paste should be here tomorrow for me. Then I can start on smoothing the ports and bit and start assembly. I got a digital spring tester from Proform. Hope to get it this week. Bottom end is already assembled.