Devek Header Install Party: Santa Cruz 8/30
#17
Addict
Rennlist Member
Rennlist Member
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
Bill,
If at all possible, don't get hurt.... I still need your assistance at the dyno that evening. Thanks.
Oops, that's Wednesday... Still don't get yourself hurt.
If at all possible, don't get hurt.... I still need your assistance at the dyno that evening. Thanks.
Oops, that's Wednesday... Still don't get yourself hurt.
#23
Rennlist Member
Thread Starter
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
Hour three.
Ac dropped and it's mount
Alternator down
Oil filter down
Flexplate maint complete
Oil pressure sender replaced
Pass manifold off
Two phone calls from work taken
The two front drivers side header nuts remaining.
More l8r.
Ac dropped and it's mount
Alternator down
Oil filter down
Flexplate maint complete
Oil pressure sender replaced
Pass manifold off
Two phone calls from work taken
The two front drivers side header nuts remaining.
More l8r.
#26
Archive Gatekeeper
Rennlist Member
Rennlist Member
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
Fighting the gasket rings.
#30
Archive Gatekeeper
Rennlist Member
Rennlist Member
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
And if you can't get them out, can't you just leave 'em and mount the header flanges flush up against them? Or is there 'crush' built into them, so that not replacing would give you an exhaust leak? I don't recall ever hearing/reading that they're one time use only (?)