1 month to SITM!!! Mark your calendars!
#317
Rennlist Member
I remember greg and I battling it out to the last minute on our resto's, I tore a cam seal and "F" at -2d days from liftoff on startup after spending 40 hours in the garage in 3 days, but took the wife's car down, he made it but caught a turkey on the way back. EPIC TRIP. I rode with cambo and hew nuked his transmission, then with Jadz928 and helped him with his lines through the tight stuff, then pearl broke or something for a year.
can't wait to see you fuitcakes again, will miss HACKER and his BEER!!!
can't wait to see you fuitcakes again, will miss HACKER and his BEER!!!
#318
Rest in Peace
Rennlist Member
Rennlist Member
Join Date: May 2006
Location: Bird lover in Sharpsburg
Posts: 9,903
Likes: 0
Received 2 Likes
on
2 Posts
I remember greg and I battling it out to the last minute on our resto's, I tore a cam seal and "F" at -2d days from liftoff on startup after spending 40 hours in the garage in 3 days, but took the wife's car down, he made it but caught a turkey on the way back. EPIC TRIP. I rode with cambo and hew nuked his transmission, then with Jadz928 and helped him with his lines through the tight stuff, then pearl broke or something for a year.
can't wait to see you fuitcakes again, will miss HACKER and his BEER!!!
can't wait to see you fuitcakes again, will miss HACKER and his BEER!!!
I do have high hopes of Hans and Katie though, and a few others.
We need as many pretty women as we have pretty cars, to keep the balance of nature, well, balanced.
PS, dont look for me to help out, Uncle Mitch is my date, and is a damn near twin, so you know what that means.
Our race was fun, and if for not the issue with the seal, you would have won, hats off to ya man.
#324
Addict
Rennlist Member
Rennlist Member
ao,
hate to differ with you but its 103 ftlbs. page 42-02 wsm, wheel carrier to lower suspension link. (140nm)
hate to differ with you but its 103 ftlbs. page 42-02 wsm, wheel carrier to lower suspension link. (140nm)
#326
Drifting
This morning, I went to back them and one nut is a little suspect. I can't get the nut off even after double nutting the other side.
Hopefully if anything I trashed the nuts and not the pin. I didn’t get to try today since a couple of the big washers were less than pristine. I decided to clean them up with a wire wheel and hit them with clear engine paint. I’ll find out tomorrow it they’ll hold 103.
Otherwise, isn't there some sort of nut cracker? I have a couple extra nuts it the pin threads look good. I might chase them just to be sure.
#327
Supercharged
Rennlist Member
Rennlist Member
Thread Starter
Join Date: May 2002
Location: Back in Michigan - Full time!
Posts: 18,925
Likes: 0
Received 62 Likes
on
35 Posts
Tom is right. 103fltlbs. I'm sorry for the mis-information. I will correct my post and verify the TQ spreadsheet.
BTW, 4 weekends left to wrench, bitches!
BTW, 4 weekends left to wrench, bitches!
#328
Administrator - "Tyson"
Lifetime Rennlist
Member
Lifetime Rennlist
Member
It's getting kind of crowded at the top - unsticking for a a bit.