UPDATE, 10 16 10 Porken power chips , how to install them 85/86/86.5
#76
I just installed my second set of Ver 4.0, this time into Helmut. I used a adjustable fuel pressure reg instead of the S4 reg. Set pressure at 58psi with the fuel relay jumpered. Thanks for the tip about changing the adjusting set screw to the bolt, Ken!
I pulled the whole rack that holds the brains and used the printed tags by taping them to each brain box, alerting future owners to the chip upgrades.
Haven't driven Helmut with Ver. 4.0 yet but Zelda responds favorably to it. Need to run the Blinker on Helmut to tune the CO and adjust the idle.
Thank You Ken for bringing these products to our little market!
Some pics:
I pulled the whole rack that holds the brains and used the printed tags by taping them to each brain box, alerting future owners to the chip upgrades.
Haven't driven Helmut with Ver. 4.0 yet but Zelda responds favorably to it. Need to run the Blinker on Helmut to tune the CO and adjust the idle.
Thank You Ken for bringing these products to our little market!
Some pics:
#77
Just got my '85 auto chips, thanks Ken!
The car is a stock 85 Auto, going thru a refresh under the hood right now, gregs fuel lines, and an 88 FPR from roger.
Stock exhaust, new dual cats..
DO I need to setup for WOT, and, running California gas as well. Whats the recommendation for this..
The car is a stock 85 Auto, going thru a refresh under the hood right now, gregs fuel lines, and an 88 FPR from roger.
Stock exhaust, new dual cats..
DO I need to setup for WOT, and, running California gas as well. Whats the recommendation for this..