Average Cost of Powder Coating the Spider
#16
Addict
Lifetime Rennlist
Member
Lifetime Rennlist
Member
Joined: Jun 2000
Posts: 40,449
Likes: 98
From: Insane Diego, California
Tougher, actually.
It's been a few years but there's many specialty coating shops that will do it.
I had mine done at a place in Escondido - it may have been these guys:
http://www.olycoatings.com/
Here's how mine turned out:
I had mine done at a place in Escondido - it may have been these guys:
http://www.olycoatings.com/
Here's how mine turned out:
#18
#19
hey hacker, i use a normal 4" dewalt grinder along with the dewalt "grinding wheels" that they make for steel. by no means was it any easier but i believe you could do 1 spider with less than 1 wheel. cheaper than those "sanding disc" if that is what you were using. i've never done a spider but between rat rod frame building and all my 4 wheel drive off-road stuff my son and i are always grinding something.
#21
Tougher, actually.
It's been a few years but there's many specialty coating shops that will do it.
I had mine done at a place in Escondido - it may have been these guys:
http://www.olycoatings.com/
Here's how mine turned out:
It's been a few years but there's many specialty coating shops that will do it.
I had mine done at a place in Escondido - it may have been these guys:
http://www.olycoatings.com/
Here's how mine turned out:
#22
I've had these silicone hoses on since day two........
Need some?
--Russ
Last edited by largecar379; 12-14-2008 at 02:27 AM.
#28
I ike Hackers Red Spider, i think that looks great.
As for a target price, i would shoot for $150-$200 honestly. There is really no set price even for a specific company, it just depends on who you ask and what kind of mood they are in on that day.
As for a target price, i would shoot for $150-$200 honestly. There is really no set price even for a specific company, it just depends on who you ask and what kind of mood they are in on that day.
#30
Price came in at $220.00. But this includes the spider, water cross-over, thermostadt cover, few bolt heads, and the oil fill can. Two coats of powder filled all the pits in the castings. I'm happy with the work.