928mac

Well I took a few pictures today well on the evening coffee run.
Getting the wife coffee is a good excuse to go for a rip





BTW there is no front air-dam because it is 10 inches and I cant get in a drive way, so its off

genikz

Gutted, cleaned and painted the drivers-side door of the '78 928 Euro S race car

Rob Edwards

stuartbrs

New Exhaust

Vilhuer

Stainless X made locally. Rear end fits right into stock middle silencers so there is no need to mess around with any aftermarket clamps which will leak anyway.

Vilhuer

Converter version of the local X.

JPTL

Erkka, you're getting some really nice 'local' work done there in Finland. Are you giving the fabricator the specs/measurements or is he going on his own?
(photo - Ernest Wong)

Vilhuer

We gave them stock cat converter setup to use as sample. So far only problem is lambda mounting point in middle of X. It points too much straight up and there isn't enough space between X and heat shield for lambda sensor. Should be easy fix by changing mounts angle. Everything else fits very well. Whole point of the exercise was to get parts which are easy to install using factory mounting points. Every other X style I know has problems at exit. These are same lenght, have same pipe diameter and distance between pipes as stock setup. Same company has earlier done stainless silencer for '78 MY using stock part as sample. So we knew they do good work.

Ian S4

From a 1986 brochure

vanster

Timeless design. A good design will last forever

depami

dogleg

th_280.jpg?t=1336259184

depami

steve322s

its an automatic?

MainePorsche

Wires exposed in 2 places
Harness sheathing split
Vacuum line not connected
Bell house ground not attached