Group Header buy #2
#47
Addict
Rennlist Member
Rennlist Member
Originally Posted by jyoon
do you need springs or bolts to keep these things together?
#48
Addict
Lifetime Rennlist
Member
Lifetime Rennlist
Member
Two sets we ordered arrived few days ago. Titanium coating (on both outside and inside) was done by Embee Performance. Big thanks to Mark for setting this up.
NICE!!!
is that a common coating for heat? I always thought it was ceramic or something. they look great.
#50
Addict
Rennlist Member
Rennlist Member
I don't know what that coating material is exactly but think it's available in several colors.
Nick, I think we did meet at the ring next to my friends S4. One set is heading into it.
Nick, I think we did meet at the ring next to my friends S4. One set is heading into it.
#51
Addict
Rennlist Member
Rennlist Member
Few quick pics taken with mobile phone during exhaust building at local shop.
Twin 3" all the way to not yet installed rear muffler and single 4" after it. Tip will be as large as stock S4 bumber opening allows. X was made on the spot and might not be best possible but it must help anyway. Header installation was real pain but final result is great. They fit really well and car feels much more powerful than before according to owner. Into dyno soon. Too bad there isn't representable before results.
Twin 3" all the way to not yet installed rear muffler and single 4" after it. Tip will be as large as stock S4 bumber opening allows. X was made on the spot and might not be best possible but it must help anyway. Header installation was real pain but final result is great. They fit really well and car feels much more powerful than before according to owner. Into dyno soon. Too bad there isn't representable before results.
#53
Under the Lift
Lifetime Rennlist
Member
Lifetime Rennlist
Member
That X looks good to me. Nice job. This was put together by a local muffler shop? Wow! I wish those guys were nearby.
What kind of mufflers are those?
What kind of mufflers are those?
#54
Addict
Rennlist Member
Rennlist Member
More pics is not a problem. Just takes few days before I see it finalised. It was done by http://www.eurostainless.fi. They have been around for long time. Cost is little under $2k. Not exactly cheap but more than half is material costs . Not sure what mufflers they used. If I would have to quess I'd say they are http://www.ferrita.se products as that's what they sell.
#56
Addict
Rennlist Member
Rennlist Member
Originally Posted by Sterling
Are you planning on putting anything between the primaries and the collectors to seal it?
#57
Addict
Rennlist Member
Rennlist Member
We did some more tuning with SharkTuner yesterday evening and captured this short video also. http://members.rennlist.com/vilhuer/P1030407.mpg
Couple more mobile phone pictures. Still waiting for rear muffler. Front section fits very well. So far no problems in speedbumps or bad condition local roads either. It comes only slightly lower than stock system.
Couple more mobile phone pictures. Still waiting for rear muffler. Front section fits very well. So far no problems in speedbumps or bad condition local roads either. It comes only slightly lower than stock system.
#58
Race Car
Originally Posted by Vilhuer
We did some more tuning with SharkTuner yesterday evening and captured this short video also.
http://members.rennlist.com/vilhuer/P1030407.mpg
http://members.rennlist.com/vilhuer/P1030407.mpg
#60
Addict
Rennlist Member
Rennlist Member
Originally Posted by John Speake
Did you only tune mixture, Errka ?