84S Starts, Dies Twice, then No Start
#62
Rennlist Member
Glad it was simple. When you pull the panel, push thatterrminal out and look at it there is a little barb that catches in the terminal block to prevent that from happening. You might want to bend that out a bit so it catches better.
#63
Three Wheelin'
Join Date: Nov 2004
Location: Gatineau/Ottawa Canada 84 928S triple black
Posts: 1,372
Likes: 0
Received 1 Like
on
1 Post
It was not the initial problem but it was a major pebble in the gear so to speek.
Yes this was my finding when I took a closer look at it this afternoon.
That little barb was flat with the terminal.... Pushed it out and now it is very much "hoocked" in it's place.
Thanks for the heads up though.
#64
Rennlist Member
Hi Dan,
My engine dying occasionally thread had the same condition on the yellow connector just to the left of yours. The little A3 and A4 locking tabs had bent back and no longer locked into the connector. When pushed out they clicked into place and seem to be holding fine.
Good luck
My engine dying occasionally thread had the same condition on the yellow connector just to the left of yours. The little A3 and A4 locking tabs had bent back and no longer locked into the connector. When pushed out they clicked into place and seem to be holding fine.
Good luck