Jay Wellwood

Got mine yesterday - thanks!

Voith

Great!

I checked the numbers yesterday and some are in ''notice was left because an authorized recipient was not available'' status. Check your mail gentlemen..

This is what's left, next batch in 2021..

Doyle623

Hey, glad I found this thread! Do you happen to have any of these left or have a timeline for the next batch?

Voith

Hey

I think I still have exactly what is on the picture above so 3 early and 6 or 7 late pairs.

PF

Hi Voith

Just found this thread and your efforts to keed improving on these cars! Great job and thank you!🤝

If available I would like to sign up for 2 early and 2 late sets.

Kind regards
/Peder

Zirconocene

Hi Voith-

If these fit on a 968 (which I think they do), I would be in for 2 of the late sets.

Cheers

Sam Lin

In for 3 late sets here.

Sam

Voith

Ok, PF and Casey have what's left of early seals, no more early left.

Late:
PF: 2 sets
Zirconocene: 2 sets
Sam Lin: 3 sets

I think this is all that's left. I have to find the ''stash'' today as it is burried deep in my garage somewhere. Patience please.

T&T Racing

These are great seals, a little challenging to install. I followed this procedure. Prep the seal in 125F water, leaving the seal to soak for several minutes. Apply liquid detergent to the ring of the aluminum end cap. Stretch the seal over the end cap making sure it is oriented properly. Might need to use a "tool" in walking the seal into the ring. It might take a few tries of reheating to be successful.

Voith

Late seals fit on 968.

Voith

Found them, however I Only have 6 late pairs. Sam Lin would 2 pairs be ok for you?

Voith

I'll send out on friday, my paypal is gorc666@yahoo.com Price with shipping is $40/set, please include full address and which seals in paypal comment section.

Voith

All seals are gone. Next batch probably in 2022.

PF

Recieved mine today, thanks 👍

Spitfire944

Hello Voith. I have an early 944 (1985.1). I know I’ll be doing the balance shaft re-seal project at some point. Probably sooner rather than later. How can I secure a set of these upgraded balance shaft end seals? Will they really not be available again till sometime in 2022? Great job of creating this upgrade. Is this new seal holding up well for all that have installed them?