Late 944 Dash LEDs...a reference post
#16
Not Special
Rennlist Member
Rennlist Member
Thread Starter
...found a listing of the bulbs in the climate control module, however, in this thread: https://rennlist.com/forums/924-931-...d-install.html
Here it is: http://members.rennlist.com/billthe3...scriptions.htm
Last edited by Wipeout; 11-16-2014 at 10:10 PM.
#18
Not Special
Rennlist Member
Rennlist Member
Thread Starter
#21
Master Warning LED flashes all the time
I can live with it but thought you should all know. This is on a 89 944S2.
#22
Three Wheelin'
I ordered three of the dash illumination bulbs listed above:
Dash illumination: 3 194 LED Bulb - 5 LED Wide Angle, Natural White (P/N: WLED-NW5)
So here is a picture of the new bulb with the old bulb. Did I order the wrong thing? Am I supposed to pull the old glass bulb out of the little white plastic holder and put in the new one?
Dash illumination: 3 194 LED Bulb - 5 LED Wide Angle, Natural White (P/N: WLED-NW5)
So here is a picture of the new bulb with the old bulb. Did I order the wrong thing? Am I supposed to pull the old glass bulb out of the little white plastic holder and put in the new one?
The following users liked this post:
Tiger03447 (09-13-2022)
#23
Advanced
I just did this update. Directions from the original poster are great to say the least.
I got these twist holders to go along with my bulbs -
https://www.superbrightleds.com/more...se-socket/704/
but I believe you can reused the stock bulb holders. If I remember correctly the bulb pulls right out.
I got these twist holders to go along with my bulbs -
https://www.superbrightleds.com/more...se-socket/704/
but I believe you can reused the stock bulb holders. If I remember correctly the bulb pulls right out.
#24
Three Wheelin'
Thanks for that! I'll take another try at pulling the bulb out of the holder, I was probably being too gentle. If not I'll order up some holders like you did.
Update: pulled the old bulb out and reused the original holder. I can now see my dash at night. Great success!
Update: pulled the old bulb out and reused the original holder. I can now see my dash at night. Great success!
Last edited by chrenan; 10-17-2015 at 08:39 PM.
#25
3rd Gear
Join Date: Aug 2016
Location: Wimborne dorset
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
Hi all, i had a big issue with my dashboard lighting driving down to the middle of france for a holiday. looking at the light tunnels and i tryed chrome paint but that did not work so i used ailuminum tape which works. but i wanted to switch to leds and to a red light, i have gotten some 6 led smd, they work in the dash out of the car on an 12v battery, but once pluged into the car on the dimmer circuit they dont work, when buying them i asked if they would work on a dimmer circit... - ok these were from ebay, and not superbrightleds but i was not going to pay the 20 $ shipping to the uk/france... can any one help put some light back into my dash?
#26
Not Special
Rennlist Member
Rennlist Member
Thread Starter
Hi all, i had a big issue with my dashboard lighting driving down to the middle of france for a holiday. looking at the light tunnels and i tryed chrome paint but that did not work so i used ailuminum tape which works. but i wanted to switch to leds and to a red light, i have gotten some 6 led smd, they work in the dash out of the car on an 12v battery, but once pluged into the car on the dimmer circuit they dont work, when buying them i asked if they would work on a dimmer circit... - ok these were from ebay, and not superbrightleds but i was not going to pay the 20 $ shipping to the uk/france... can any one help put some light back into my dash?
#27
3rd Gear
Join Date: Aug 2016
Location: Wimborne dorset
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
yes what i forgot to say on my first post was, i took the bulb holders and marked them with red and black, - and pluged the blubs into the holders and put 12v to them plus to red black to neg and if they did not work turned them around tryed again, they lit up, replaced them into the dash with the red bing at the top, and connected the battery to connections for ground and lighting and got them to show up.
i have sent an message to the guy on ebay asking he he got any clues and is sending another pack..
i might try to pull off the red plasic to see if i can solder in an resistor to them.... but they look packed alrdy.
if all ease fails i have to bite the bullet and get 3 bulbs from superbriteleds and pay $20 shipping for $12 bits ( i cant seem to find places in uk apart from ebay and items from them alrdy did not work but so far have only cost me £12 including postage to france £1.99/2.09 is what i paided so far for 10 bulbs each.... they all work just not in dimmer circuts so i can see i got spare bulbs for an project... ) but that needs me to have a job....
i have sent an message to the guy on ebay asking he he got any clues and is sending another pack..
i might try to pull off the red plasic to see if i can solder in an resistor to them.... but they look packed alrdy.
if all ease fails i have to bite the bullet and get 3 bulbs from superbriteleds and pay $20 shipping for $12 bits ( i cant seem to find places in uk apart from ebay and items from them alrdy did not work but so far have only cost me £12 including postage to france £1.99/2.09 is what i paided so far for 10 bulbs each.... they all work just not in dimmer circuts so i can see i got spare bulbs for an project... ) but that needs me to have a job....
#28
Instructor
Join Date: Aug 2015
Location: Washington, DC
Posts: 194
Likes: 0
Received 0 Likes
on
0 Posts
https://grassrootsmotorsports.com/fo.../105890/page2/
About halfway down this page I detail my LED upgrade. It's worked out well for me, using stuff I had around anyway.
Just another way to do it.
About halfway down this page I detail my LED upgrade. It's worked out well for me, using stuff I had around anyway.
Just another way to do it.
#29
3rd Gear
Join Date: Aug 2016
Location: Wimborne dorset
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
yes i have though about geting 3 stips of leds that go where the light tunnels go, i just dont have the stips of leds, risitors, and an lot of paticent of putting them in the culster ok i got two cluster to play with, but i would like to go down the replament blub led's than whire up it myself.
#30
It looks like superbrightleds.com has discontinued the "low power" B8.5 red and green bulbs that were listed in the original post. All that's available are the "high power" version (the ones that are used for the !, turn, and high beam lights). The difference in brightness is 2 vs 20 lumens. I'd rather all the dash lights not be the super bright ones... has anyone used an alternate source for bulbs?