Gauge Pods?
#4
Addict
Rennlist Member
Rennlist Member
I have emailed them everyday and given them the time to answer but they have not. In the morning,,,THE PHONE STARTS RINGING AND WILL RING UNTIL I GET A HUMAN VOICE AND FIND OUT SOMETHING.
I was going to give them until the 15th but since they haven't been answering their email,,it is time. I'll post a response tomorrow.
I was going to give them until the 15th but since they haven't been answering their email,,it is time. I'll post a response tomorrow.
#5
Burning Brakes
Join Date: Nov 2001
Location: San Diego
Posts: 1,084
Likes: 0
Received 0 Likes
on
0 Posts
I hope you folkes didn't order these from us! Did you? If so, there has been a mistake...we always answere the phone!! No one said in the posts who they ordered them from?
#6
Drifting
you guys sell gauge pods?!?
where were you when we were going through hoops getting these made? (LoTek Engineering)
If these are nice (they'd better be), then you and Tim should call these guys and stock some - this gauge pod replaces the entire factory A-pillar, and should look "stock"...
where were you when we were going through hoops getting these made? (LoTek Engineering)
If these are nice (they'd better be), then you and Tim should call these guys and stock some - this gauge pod replaces the entire factory A-pillar, and should look "stock"...
#7
I havnt seen anything from lo-tek yet either. Am i just too patient?
Most parts are interchangeable between the 924 and 944....The a-pillar trim should be the same.
Originally posted by Devildog2067:
<STRONG>(They're supposed to fit 924 interiors right?)</STRONG>
<STRONG>(They're supposed to fit 924 interiors right?)</STRONG>