pjburges

Finally decided to become a member, and Id like to clean up my garage a little. Most of this stuff is junk to me, so Im looking to get rid of it.

First of all a trade - I would like to trade a 968/951 wheel hub w/ bearings for 1rear turbo brake rotor (late offset) and a set of rear brake turbo pads. These can be used I just need them to be in decent working order.

Or Ill take $75 for the hub.

Now the for sale:

A set of 1986 Turbo hubs, spindles and rotors - The hubs have nice bearings - spin well. The rotors are flat and right near 28mm (new). - $175

1986 Turbo brake dust shields - one is painted one is cadmium plated - $15

A set of front 944S rotors, these are rusty, albiet they only ran for a few months and wear wise are essentially new as far as I know. - $40

Leaking Power-Steering pump - $15 - SOLD

Leaking Power steering rack (comes with tie rods early offest) - $25- SOLD

Power steering intermediate shaft - $40? Just offer something for it.

Power hatch motor - $20

Power sunroof motor - $40

1 Most likely Good A/C compressor - $100

1 (Maybe?) Good A/C compressor (clutch is no good) - $35

1 Good Bosch Ignition Coil (original- used) - $20

2 Good late offset upper strut mounts - $40

Early 924/944 3-spoke steering wheel. Good leather but has been unstitched, will need to be re-stitched. - $20

1986 951 Steering wheel (no air-bag). Leather is worn out, will make a good core to be refinished - $15

1 Brake Master Cylinder Core for 1986 turbo or 1986-87 924S - I believe its the ATE unit. (I think its leaking from the back - but can be rebuilt and makes a good core and comes with resivoir) - $15

Ill have to dig around to see if there is anything else.

All these prices are negotiable. Hopefully someone here can find a use for it because Id like to be rid of it!

Thanks!

pjburges

bump

Dimi 944

PMed.

Yabo

Any chance you have the door ding strips for the driver side?

pjburges

No, I sure dont have any strips. - Sorry!

Dimi 944 - Im working on a packaging method/ shipping quote and Ill have to get back to you!

Thanks for the inquiries!

jtsporsche

is this front and rear?

pjburges

Just front. Ive also got an extra front hub for a late offset turbo car.

I will eventually have a set of rear 86 turbo hubs, but I am process of swapping offsets on my car so I wont have those until I can take my car out of action and do the wrenching. - Let me know if you're interested!

Dimi 944

I am interested in the rears as well.

FRporscheman

PM sent.

jtsporsche

no thanks, i pass