Safe to reuse this part?
#1
Rennlist Member
Thread Starter
Safe to reuse this part?
I was just digging into the front of the engine to replace what I suspect will be a leaky crankshaft seal. Anyway, when I removed the balance shaft belt drive gear, it appears that the keyway is messed up. I wondering what everyone thinks - reuse or replace it. I guess the worst case is that my balance shaft timing will be off slightly.
http://www.flickr.com/photos/1056022...68603/sizes/l/
http://www.flickr.com/photos/1056022...68603/sizes/l/
#5
RL Community Team
Rennlist Member
Rennlist Member
I can grab one from a junkyard for you tomorrow. I'll give it to you for my cost plus shipping. It shouldn't be more than $10 or $15. Let me know if you want me to get it.
I think it would probably be OK but why not address the issue while you can?
I think it would probably be OK but why not address the issue while you can?
Trending Topics
#9
Rennlist Member
Thread Starter
Sorry - I had computer problems yesterday and this morning. I will take you up on this if you are stll going. PM sent as well.
#12
RL Community Team
Rennlist Member
Rennlist Member
It was too cold today to even leave the house. I sat indoors and just shivered my way through the hours. Hopefully tomorrow it will be a little warmer!
But if someone has one in-hand, it could save me a trip to UPS and save you some garage space to send yours to crooster. I will go find one unless someone else volunteers to send one.
But if someone has one in-hand, it could save me a trip to UPS and save you some garage space to send yours to crooster. I will go find one unless someone else volunteers to send one.
#14
RL Community Team
Rennlist Member
Rennlist Member
Alright I tried 2 more junkyards and no 944s. I feel really gypped, because I usually see at least one 944 (with engine). Sorry but I guess I can't help you!