Gary R.

I'm catching up. I just finished up doing all the exhaust/heat pipes using silicone adapters (sheesh those 2.5"-2" reducers were $$)! and hacked off the rear (OEM) sway mounts. Talk about wimpy-***. I'll weld on the Wevo mounts and install the adj. Smart Racing stuff tomorrow. That rear bar is MASSIVE! I'll leave all the new ignition stuff (my Magnacore 10mm wires arrived today and are in a box with the new dizzy cover/rotor/W4Cs plugs) until after the body and interior is done.. Then will come the MSD 6AL/Blaster 2 and the Leask / Innovate stuff...

Gotta check out the Boost guage sender. It reads .4 on ignition turn on and goes up quick on rev. Disconnect the lead on the sender and it buries beyond 1.0.. Just read that if I ground the wire it should go to 0.. will check tomorrow..