BFG G-Force Sport Question
#1
Pro
Thread Starter
Join Date: Oct 2005
Location: High Desert, So. California
Posts: 536
Likes: 0
Received 0 Likes
on
0 Posts
BFG G-Force Sport Question
The Falkens on my S2 Cab wore thin after 6K street miles so I bought some BFG G-Force Sport tires in the factory sizes for my car. The Pressure is at 36/44. When I turned onto an onramp, the car understeered and started to slip. the tires were warm as i had already driven about 15 fast miles on them. Are the pressures too high? Do the tires really stink this bad? The Ziex didn't slip this bad unles i was really haulin'. What should the pressures be? Thank you in advance.
#2
Former Vendor
The pressure sounds a bit high. Try reducing it 2 pounds per corner and see. Are they so new the mold release isn't worn out of the rubber compound yet? You didn't say how many miles were on them.....
#3
Pro
Thread Starter
Join Date: Oct 2005
Location: High Desert, So. California
Posts: 536
Likes: 0
Received 0 Likes
on
0 Posts
The tires have about 200 miles on them. The pressures are what Porsche recommends according to the Gas Cap. Will 2 PSI make such a big difference?? Some people have said go as low as 30/30 but that just seems too low, I don't want to overheat and ruin the tires. I drive spiritedly and fast around where I live, it's the desert so not to many cars around, when there are cars within 1/4 mile I slow down to reasonable traffic speeds.
#4
Former Vendor
200 miles isn't much. If they haver not seen rain yet mold release may still be impregnated into the rubber compound.
2-3 lbs is the max you should start with. You do not want to start underinflated and move up, you could damage the tire.
30? No way.....
2-3 lbs is the max you should start with. You do not want to start underinflated and move up, you could damage the tire.
30? No way.....