When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I am not sure that I would even install that on my golf cart.
Don't get me wrong, wasn't endorsing it. I have no idea if it's any good. I'm going with the GMG WEC half cage myself. Just providing the info the original poster requested.
Not sure the GT3 rear deck has the threaded inserts in the body from the seat belt attachments of the regular 992 cars that that bar uses.
I would have preferred a simple harness-only bar like this if it existed at the time. I almost just had one made myself but in the end went with a BBi bar.
I am not sure that I would even install that on my golf cart.
LOL
I would..
Originally Posted by Mech33
Not sure the GT3 rear deck has the threaded inserts in the body from the seat belt attachments of the regular 992 cars that that bar uses.
I would have preferred a simple harness-only bar like this if it existed at the time. I almost just had one made myself but in the end went with a BBi bar.
I figure it needs rear seat belt anchor points, I guess there is no other way then to weld in plates, even with a half assed harness bar.
I figure it needs rear seat belt anchor points, I guess there is no other way then to weld in plates, even with a half assed harness bar.
When I was looking to make it, I was just going to use the same shock tower mounting stud area that all the 992 bars use, and bring the plate stock straight out through the carpet there, and attach a horizontal bar between the two plates.
Yesterday, 12:26 PM
Harness bar minimal roll bar
