When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I added a USB port for power. I searched high and low for a rectangular USB port --- circular ones are everywhere, but rectangular ones are super hard to find.
I visited the R Gruppe meet up at EASY in Emeryville. Then drove down to Parts Heaven and got some bits and pieces for the 993 like a replacement tail light because one cracked.
There was a very nice RS tribute there that got lots of attention. Here are a couple pics:
There were three other 993s there in addition to mine.
Last edited by Spyder_Man; 08-08-2016 at 04:48 PM.
Reason: fixed the photo links since the mobile app sux!
it comes supplied with OEM fitment clips 999.049.011.40 so that it can be fitted in a none intrusive way.....
mmmmm real carbon, not plastic with a film on :hand:
I'll get this fitted over the weekend :thumb:
Edited to show fitted pics...
Its a 5 min job the main level of difficulty is actually getting your fingers in to remove and replace the attachment caps
Old and saggy with heat :nooo:
Here you can see one of the 5 retaining "caps". You just have to use your fingers tips to wiggle it side to side whilst trying to pull away. Some are pretty easy to get at some very tight if you have chunky fingers
An original cap removed on the right and a replacement cap provided which is smaller. The replacement is threaded and has to be screwed onto the lugs ie not just pushed on like the original. This is harder to do with the access restrictions....
And the finished job, remember this part is not original and has been custom designed / made to hide the saggy insulation. Just as Porsche should have made it :thumb: