FRUNKenstein

$74.30 each from warehouse33auto.com with the 10% "RENNLIST" coupon code:

http://www.warehouse33auto.com/parts...05/10/0/5552/0

They usually have cheaper shipping also.

Slakker

^^ +1. Good Rennlister.

Device2

I too installed the Rein brand ones about 5K miles back and they seem to work fine. One thing that you may also want to look at since it happened to me. You may want to look at the state of the transmission mount. My indi brought it to my attention after driving my car and suggesting that I get the motor mount replaced. The Transmission mount on my car was in bad shape from having to support both the tranny and the motor due to the bad/extended motor mounts. I replaced it as I was dropping my whole motor and trans, now pressing it in and out was a bit of a pain but plenty of DIY info and tutorials for both the motor mounts and tranny out there.

Try FCP Euro.com $70.99 each, Free shipping.

Slakker

Just replaced my motor mounts with the set from Rein. They looked identical to stock. No noticeable difference in tail pipe position. Oh well.

Woodman71

Were the pipes snug before you replaced? I'm betting there would be a noticeable difference in mine...

Slakker

Ya, they were within an 1-2".

strathconaman

Based entirely on this thread, I went ahead and replaced the mounts on my 2002 C4S. The results are stunning. Easiest repair ever.

Slakker

Nice! Which ones did you go with?

spud72

I did mine this weekend with Reins and I think the pipes did go up a bit, it wasn't dramatic. The vibration of an unoccupied seat at idle is 95% gone now.

Very easy to do though, although one of the grommets for the airpump with the built in nut rotted away and I need to order another one though

strathconaman

I went with the Reins mounts.

Giorginetto

Any good tips on which mounts to go for and from where for a 03 996 carrera ?

nrp3

I went with the Rein ones for my 03. I felt it was as easy a job to replace as anyone else. I got mine at Rock Auto if I remember correctly. Shop around.

mdreef

My cabriolet is 100% stock so I went with "Rein" purchased at AutohausAz which is frequently less expensive than Pelican Parts. I paid $95.99 each.

It's one of the easiest repairs on the 996.

Good luck.

nrp3

Mine