When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Forgive my ignorance but working on this engine has me paranoid beyond the norm
These head gasket surfaces are a bear to clean. I am using some professional carb cleaner and a fine 3m abrasive pad by hand. Am I correct in my approach. Seems to be slow and tedious and I am starting to question how clean this aluminum needs to be.
Have done many ls series GM engines but they are newer and the gaskets seem to come off cleaner due to less age.
I would put the scotchbrite away,
go buy a fresh pack of good razor blades and change then regularly
Hold the bade perpendicular to the surface and scratch back and forth.
Use a straight edge to see if the bores are flush with the sides of the block
if not flush then decking should be performed.
I would put the scotchbrite away,
go buy a fresh pack of good razor blades and change then regularly
Hold the bade perpendicular to the surface and scratch back and forth.
Use a straight edge to see if the bores are flush with the sides of the block
if not flush then decking should be performed.
Thank you sir! I did start by dragging the blade but some of the deposits were extremely stubborn. Will get back to it and see how it goes. I appreciate it!
I love green scotchbrite scrubby pads for this kind of thing.
They aren't aggressive or abrasive, just scrubby...
Light hand pressure and a little bit of oil or brake cleaner will go a long way to make the surface nice and clean.
Be careful not to take off too much material in one spot by scrubbing it like a mad man. The deck and head surface need to be flat and uniform. If you get to a point that aluminium has to be scrubbed away to get to the corroded/pitted sections, than you either stop and use the parts as is or have them re surfaced at a machine shop.
Be careful not to take off too much material in one spot by scrubbing it like a mad man. The deck and head surface need to be flat and uniform. If you get to a point that aluminium has to be scrubbed away to get to the corroded/pitted sections, than you either stop and use the parts as is or have them re surfaced at a machine shop.
Yep. That's my problem. I am so paranoid about doing more damage than good. Scotch Brite can leave ano abrasive dust around that that can damage bearings etc. I tape and plug the drain holes when doing this work but am trying to be careful with making waves in the aluminum as well. Although working by hand would make that tough to do, it can happen.