jsheiry

Any good close up pictures of 968 engine on stand would be greatly appreciated.

Assembling the last of my engine and have many little wiring harness tabs that need put on near balance shaft housing covers etc...etc...etc...

Should have taken better photos myself, now I have a parts washer full of little tabs that the Workshop manual does not detail very well.

Thank you very much.

touareg

These are pics from a 3.0 that was used for training. So I don't know how accurate it is. It was NOT pulled from a running car. That is my understanding.

jsheiry

Toureg, thanks for the pictures. The motor decked out in the intake manifold and exhaust manifolds is obscuring the view Im looking for.

Mainly the balance shaft housings on each side, the oil cooler housing, etc...

The all have the mounting screws with some occasional tabs for wiring harnesses

Looking for good pics of these tabs in various spots.

Thanks

V2Rocket

That's a really sweet engine stand.

touareg

Unfortunately when I collected these shots from the internet, that one was not there!

oppositelock

These might help. Mitch

thomasmryan

Luke (parts guy at Sunset) said the smaller black clips where NLA so I used the grey clip for the number 4 plug wire.

jsheiry

Mitch, those pictures are GREAT. Thats exactly the stuff Im looking for.

Any chance to get a close up at the front of the motor?

Thanks John

oppositelock

Jsheiry,
Sure, no problem. I am assuming the wiring running along and behind the rear belt cover?.
I'll check back tomorrow morning and send the photo tomorrow afternoon (Sunday). Mitch

oppositelock

Do these help. If not, let me know. The engine is going back in soon. Mitch