I've been stripping my interior carpet in preparation for installation of a new carpet set ---- I laid everything out and it makes sense --- however I have two pieces that I'm not sure what they are --- anyone have any ideas?

Thanks

 

The first piece with ??? goes over the back of the tunnel. The two longer pieces have finished ends and overlap.

 

Thanks --- doesn't this piece shown below go over the back of the tunnel? that's why I'm confused ...

 

Ah, I think maybe here is a possible answer ---

https://rennlist.com/forums/964-foru...r-install.html

 

I take that back ... I already have the piece that goes over the center console .... With a seam where there should be a seam going from the upper piece to the lower piece. Still baffled at what the other piece is...

 

Might be an extra piece for a cab install. It would go behind the rear seat pocket for the top.
I need that piece if you don't use it. Mine has a black mark that won't come off.

 

Ahhhhh. Thanks - appreciate the info as I dont have a cab to look. I will report back as well what the vendir indicates as well once the holiday weekend is over.

BTW are you sure you want my piece? My new carpet is not classic grey. It is a slightly warmer grey sikverknit. PSL-10 color code. Comparison between PSL-10 and CG is in the 2nd pic.

Yes, a lot of Elbow grease for a subtle change .... OCD.

 

I'll look for a classic grey. Nice color for the change out.
Thanks

 

I think my conclusion in post #5 is wrong because C23, which is the carpet that goes over P2 and P3 combined, has a different seam than "M2 or M23".

P = original plastic piece
C = original carpet
M = new carpet

P3 originally sat on top of P2 and was covered in one shot by C23.