multi21

Dell,

It doesn't look like you have a bar in there yet? Are the GT3 seats in?

va122

I like the yellow/black theme. Nice.

va122

Hey, did you get the nittos?

LVDell

I have the Teq harness rollbar and GT3 seats along with various other goodies

LVDell

I will order them this week. Full report after the event in March.

multi21

I thought you were going to go with the black Schroth belts with yellow "SChroth Racing" lettering to match the car.

LVDell

I was but they were going to take several weeks to get in and I needed them in a week. For some reason all colors EXCEPT black are stocked and the black ones have to be special ordered. Oh well. I actually like the red ones since the lettering is yellow

va122

did you powdercoat the bar? it looks black. Mine is stainless steel

LVDell

Black? Not sure how you see black in those photos. It is just the plain stainless steel.

va122

Trick of the light I guess.

LVDell

or maybe my crappy Kodak digital camera

GhettoRacer

btw, just talked to Toyo. Trampio are not going to be in USA until about Sept.-ish. so it's pretty much Proxes RA-1 until then.

Rob in VA

Dell, from this picture, it looks like the left shoulder harness (with ASM [yellow tear section]) is on the wrong side. The shoulder harness with ASM need to be mounted on the tunnel side. So always opposite of the seat belt.

Now if you are using a HANS device, you should not use an ASM harness at all.

LVDell

That's the pax side that you see. The belts are defintely in the correct location since the shoulder straps end at the camlock with a "bent" insert that can ONLY go on one side (tunnel or outside).

Why would the "ASM-Yellow Tear Section" be located on a specific side?

Rob in VA

Dell, it's best to double-check your installation instructions.