Nitrous and Cryo2 experiments with M96 block
08-12-2006, 11:14 AM
#16
Instructor
I realize this thread is around 4 months old but I'm curious how your nitrous experiemnt turned out. I have ran a lot of cars on nitrous over the years and would love to see how your project went.
Typically with under a 100hp shot you don't need to retard timing, NX dones't even recommend it to be honest. Thats a lot of old internet logic thats long gone. Under 100hp shot just copper plugs 2 ranges colder than stock (NGK colder is a lower number, Bosch higher number) and spray it.
My GTI VR6 ran 150whp shot stock block timing no problems with an NX Direct port kit, made almost 330whp, my Talon runs nitrous but never dynoed it with it. Made 424whp on turbo only pump gas. Race gas and nitrous was a big who knows.. lol.. It runs a single nossle EFI kit like what you have 35hp shot.
http://www.dsmtuners.com/forums/atta...1&d=1103987770
Typically with under a 100hp shot you don't need to retard timing, NX dones't even recommend it to be honest. Thats a lot of old internet logic thats long gone. Under 100hp shot just copper plugs 2 ranges colder than stock (NGK colder is a lower number, Bosch higher number) and spray it.
My GTI VR6 ran 150whp shot stock block timing no problems with an NX Direct port kit, made almost 330whp, my Talon runs nitrous but never dynoed it with it. Made 424whp on turbo only pump gas. Race gas and nitrous was a big who knows.. lol.. It runs a single nossle EFI kit like what you have 35hp shot.
http://www.dsmtuners.com/forums/atta...1&d=1103987770
