Anyone seen a post with Macan front bumper removal? Searched with NO luck. Thanks

 

With the front camera, temp sensor, motor-controlled front baffles, etc., I have a feeling that there are a bunch of electrical connectors to disconnect. As a dyed-in-the wool do-it-yourselfer, I long for the day that Bentley Publishers issues a manual on the Macan similar to the one they did for the 993.

 

Getting a fully installed radar/laser system and wanted to give the installers a bit of guidance. Tons of DIY posts on the 991's.

 

It's the motor controlled louvers that I am worried about messing up. There is a bit of a bump in one of the black plastic pieces around the center intake and I suspect it covers part of the actuator for the louvers.

I want to install a stow and show license plate system and need to bolt to this piece.

 

I am reviving this old post. Does anyone have a DIY procedure for the removal of the front bumper on a .1 Macan?

 

Look here: https://www.macanforum.com/threads/d.../#post-2630175 In this thread, you'll also find a link to Flat6 Motorsports' instructions for front bumper removal.