Volk TE37 Ultra's on a GT4.
06-22-2016 | 10:28 PM
#31
Thread Starter
Three Wheelin'
Joined: Jan 2016
Posts: 1,570
Likes: 100
From: Los Angeles, CA
Why? When you can approximate it for yourself with your present alignment. All you have to do it find a 3/4" thick x 2' long and x" wide piece of ? and tape it to your front wheel/tire combo. In this case it doesn't matter that the OEM wheel is 8.5" versus the Volk at 9" since a 245 tire is wider than either. The 3/4" thickness will account for the increased section width mounting the tire on a wider wheel and will cover the increase of the offset. Then all you have to do is look down the side/fender of your car and make your own judgement.
Shouldn't take any longer than the time to drink a cold one.
Shouldn't take any longer than the time to drink a cold one.
06-22-2016 | 10:37 PM
#33
Rennlist Member
Joined: Jul 2002
Posts: 534
Likes: 17
From: FL
06-22-2016 | 10:55 PM
#34
Thread Starter
Three Wheelin'
Joined: Jan 2016
Posts: 1,570
Likes: 100
From: Los Angeles, CA
In that case your post (#26) doesn't make sense; it expresses fitment doubt.
06-22-2016 | 11:02 PM
#36
Thread Starter
Three Wheelin'
Joined: Jan 2016
Posts: 1,570
Likes: 100
From: Los Angeles, CA
They look good, they are affordable and they are forged HOWEVER they don't belong on a Porsche.
BBS, Forgeline and HRE only.
The following users liked this post:
thesaintusa (12-24-2022)
07-01-2016 | 10:58 AM
#44
Rennlist Member
Joined: Jul 2016
Posts: 139
Likes: 73
What size would you guys want these made in? 19's or 20's? Any specific colors?
I have the ability go these made and would like to understand full interest before I commit to having them made. These are not a standard run and require a special order build run to be made which is basically 10 sets.
I have the ability go these made and would like to understand full interest before I commit to having them made. These are not a standard run and require a special order build run to be made which is basically 10 sets.
