Mark this thread as Unsold
For Sale: 944, 968 Charley Arms late offset with Racer's Edge caster blocks
#1
Racer
Thread Starter
Join Date: Jan 2002
Location: Dallas,Tx
Posts: 318
Likes: 0
Received 0 Likes
on
0 Posts
944, 968 Charley Arms late offset with Racer's Edge caster blocks
One pair of late offset Charley Arms for 944 Turbo or 968 with Racer's Edge spherical bearing caster blocks. If you're reading this you probably know what you're looking at. These arms (when you could buy them) new were $1600 the Racer's Edge caster blocks sell for $372 at Paragon now. I'll sell the whole set up including sway bar mounts with delrin bushings for 968 MO30 sway bars for $1000 shipped in the 48.
SOLD
SOLD
SOLD
SOLD
Last edited by Hoosier Daddy?; 03-27-2009 at 06:10 PM.
#4
damnit! Too late.
Regards,
Regards,
Trending Topics
#9
Burning Brakes
No, Thank you Matt!
Matt has earned the quick shipper gold medal! I simply, was online at the right time to snag this super deal.
Thanks Nurburger, sorry I’ll be keeping these and all the attached goodies.
Cheers,
Jason
Matt has earned the quick shipper gold medal! I simply, was online at the right time to snag this super deal.
Thanks Nurburger, sorry I’ll be keeping these and all the attached goodies.
Cheers,
Jason
#12
Burning Brakes
Thanks Shane!
Matt, I picked them up from the post office yesterday at about 4:30pm. Excellent pieces, thanks a ton.
Now I need to open my spindle up to 19mm. Can I simply set it in the drill press and run an 18mm then the 19mm bits through?
Putting these on may mean I have to make this a track car now.
Matt, I picked them up from the post office yesterday at about 4:30pm. Excellent pieces, thanks a ton.
Now I need to open my spindle up to 19mm. Can I simply set it in the drill press and run an 18mm then the 19mm bits through?
Putting these on may mean I have to make this a track car now.
#13
Addict
Rennlist Member
Rennlist
Site Sponsor
Rennlist Member
Rennlist
Site Sponsor
Thanks Shane!
Matt, I picked them up from the post office yesterday at about 4:30pm. Excellent pieces, thanks a ton.
Now I need to open my spindle up to 19mm. Can I simply set it in the drill press and run an 18mm then the 19mm bits through?
Putting these on may mean I have to make this a track car now.
Matt, I picked them up from the post office yesterday at about 4:30pm. Excellent pieces, thanks a ton.
Now I need to open my spindle up to 19mm. Can I simply set it in the drill press and run an 18mm then the 19mm bits through?
Putting these on may mean I have to make this a track car now.