Hoosier Daddy?

One pair of late offset Charley Arms for 944 Turbo or 968 with Racer's Edge spherical bearing caster blocks. If you're reading this you probably know what you're looking at. These arms (when you could buy them) new were $1600 the Racer's Edge caster blocks sell for $372 at Paragon now. I'll sell the whole set up including sway bar mounts with delrin bushings for 968 MO30 sway bars for $1000 shipped in the 48.

SOLD



SOLD

951Saga

I'll take em... PMing.

schwank

Damn, that is a good deal. Too bad I'm spent.

User 41221

damnit! Too late.

Regards,

951Saga

Paypal sent... thanks Matt!

Hoosier Daddy?

Yes, you're too late. 951Saga has already paid...please make the PMs stop

Thanks Jason, enjoy.

Hoosier Daddy?

I think we may have set a Rennlist record bell to bell. I paid freight at the USPS counter at 4:59:05
Thanks again Jason.

Nurburger

Too busy for my own good.... This was a great deal - congrats Jason. Take $1200?

951Saga

No, Thank you Matt!

Matt has earned the quick shipper gold medal! I simply, was online at the right time to snag this super deal.

Thanks Nurburger, sorry I’ll be keeping these and all the attached goodies.

Cheers,
Jason

comatb

Matt why were you selling these? Is there another type of arm you like better?

Bill

caster951

Sweet buy Jason!

951Saga

Thanks Shane!

Matt, I picked them up from the post office yesterday at about 4:30pm. Excellent pieces, thanks a ton.
Now I need to open my spindle up to 19mm. Can I simply set it in the drill press and run an 18mm then the 19mm bits through?

Putting these on may mean I have to make this a track car now.

PorscheDoc

Yes, it takes a bit of thinking to get the hole lined up straight if you are using a drill press, but that is how I drill them out. I use a blair rotocut bit instead of a drill bit.

951Saga

Thanks Doc… will do.