Harvey in FL

I need to get to the gateway connector to install the AIM CAN cable. There are many other wire cables in the way to properly see the gateway wires. The pcar dealer said to remove the left lower dash panel where the ignition and light switches which will make it a lot easier to see the gateway wire harness.

So, does anyone have instructions on how to remove the lower panel?
I would guess the same instructions would be for a 991.


Thanks,

Harvey
National PCA HPDE Instructor
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
2015 981CS - PDK, GT Silver/Black
2008 997.1 C2 - 6 Speed, Meteor Grey/Sand Beige (gone)
2000 986S - 6 Speed, Arctic Silver (gone, but not forgotten)

ProCoach

I have posted a picture guide on how to do this. Fuse panel surround and kick panel forward of the lower door hinge needs to be removed. No need to do the lower dash or go to the gateway connector.

Harvey in FL

Thanks, I found it.

Harvey
National PCA HPDE Instructor
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
2015 981CS - PDK, GT Silver/Black
2008 997.1 C2 - 6 Speed, Meteor Grey/Sand Beige (gone)
2000 986S - 6 Speed, Arctic Silver (gone, but not forgotten)