Porsche 997.2 with AIM MXG
#1
Porsche 997.2 with AIM MXG
Scratching my head about an AIM MXG install in a 2010 997.2 with Siemens ECU. I am looking to use the "EMS SDI 3.1 Siemens" protocol but I can't get that to work. Only the "997-987_MK2_OBDII" protocol works so I am assuming that I need to splice into the wiring bundle in the footwell.
The manual states Yellow/White twisted and Black/White Twisted. Will I find those in the footwell?
The manual states Yellow/White twisted and Black/White Twisted. Will I find those in the footwell?
#2
Rennlist
Basic Site Sponsor
Basic Site Sponsor
Joined: Jun 2008
Posts: 19,273
Likes: 3,470
From: Durham, NC and Virginia International Raceway
Yes, you’ll find them in the main bundle between the fuse box and the door opening where the hinges are. CAN+ goes to yellow/white stripe, CAN- goes to black/white stripe of the same pair. I use Posi-Taps.
__________________
-Peter Krause
www.peterkrause.net
www.gofasternow.com
"Combining the Art and Science of Driving Fast!"
Specializing in Professional, Private Driver Performance Evaluation and Optimization
Consultation Available Remotely and at VIRginia International Raceway
-Peter Krause
www.peterkrause.net
www.gofasternow.com
"Combining the Art and Science of Driving Fast!"
Specializing in Professional, Private Driver Performance Evaluation and Optimization
Consultation Available Remotely and at VIRginia International Raceway
The following 2 users liked this post by Frank 993 C4S:
Matt Romanowski (10-23-2021),
ProCoach (10-23-2021)
#6
Rennlist Hoonigan
which cost no drachmas
Lifetime Rennlist
Member
Rennlist
Site Sponsor
which cost no drachmas
Lifetime Rennlist
Member
Rennlist
Site Sponsor
Joined: Dec 2001
Posts: 12,741
Likes: 1,037
From: Manchester, NH
AiM info sheet on it here as well https://www.aim-sportline.com/downlo...ns_107_eng.pdf AiM always shows the twisted pair at the ECU, but they are frequently available in other locations, most frequently by the A pillar.