dash top chrono/clock harness
 

Hello gentleman

Im in need of a harness/plug for the back of a 2011-13 dash top chronometer clock for a cayenne GTS.

The clock part # is 958 641 601 12

Does anyone happen to have one or know where to source a used one? A full harness is not a must, I merely need the plug itself with short wires coming out.

Thx

Mj

Come on now, one of you good Gents must have some Input?? :)

You'd have to find someone that has removed their clock and has no intent of putting it back and I think that is pretty rare.

I have mine apart and can take some pics and get some measurements if you want, but you can't have the plug itself :p

Gnat

Id appreciate that, Thank You.
Im willing to make a harness/plug if I can get pics showing which wire goes to each pin.

Thx

Mj

By the way, the part# to the clock I have is 958 641 601 12

Thx

Mj

OK. I'll get some pics and info for you tomorrow.

I have the sport chromo now, but originally had the plain clock. No harness change was needed (at least I assume not since it only took them about 20 minutes to do the swap and reprogramming).

Here are the particulars and some pics. I'm sorry the right side is blurry beyond use. The sun and short cable made getting the pics a pain, but I thought that one was clear while I was still in the car :(

According to my calipers it has the following measurements:

• 24.05mm long
• 8.67mm wide
• 9.42mm high
• Width of the "wings" at the bottom is 12.62mm.
• Height including the tab at the top right (facing as the front pic) is 10.80mm

The following is written on it:

• Bottom: PBT-GB10
• Bottom: 1.6
• Top: BMW6954538-01 (no it does not appear to be a real BMW part)
• Top: 77E 0-1719360-1 A

Wires are:

1. (lower left) brown
2. orange/gray (maybe orange/brown)
3. Not Connected
4. (lower right) Not Connected
5. orange/purple
6. red/yellow

Front:
http://home-ether.net:9080/Cars/Caye...lug/front.jpeg

Top:
http://home-ether.net:9080/Cars/Caye.../plug/top.jpeg

Bottom:
http://home-ether.net:9080/Cars/Caye...ug/bottom.jpeg

Left:
http://home-ether.net:9080/Cars/Caye...left-side.jpeg

Right:
http://home-ether.net:9080/Cars/Caye...ight-side.jpeg

gnat

Thank You my friend! Can you tell me, or perhaps show with a pic, which pins inside the clock itself where the harness plugs in, correspond to which wires? Since ill need to solder a wire to each pin.

Thanks Again

If you look at the front picture that is what plugs into the back of the clock when its front is facing you.

If you look there are the "wings" at the bottom and tab on the top right that control how it is lined up.

So when you are looking at the back of the clock that puts the top tab on the left and makes pin 1 the bottom right.

958 Sport Chrono Installation
 

I just installed the Stopwatch/Chrono in my 2012 Cayenne Turbo. Very easy!

958 Sport Chrono Installation
 

More pics of the installation. Dealer just updated the software to activate the option.

Did they enable the full chrono package or just enable it as a clock?

Sport Chrono palcage
 

The clock worked just by installing it. The dealer had to flash the ECU to enable the full sport chrono pkg.

Have any more details on that? My dealer said that couldn't be done without a new PCM (seemed BS to me, but as I don't have any information to the contrary I couldn't argue it).

Did they charge you anything for the flash?

Charge for flash
 

Yes, $85.00