101 Projects for your Boxster
#17
Awesome book Wayne! My wife ordered through Amazon as a Christmas present or I would have requested the signed copy.. Oh well. Its a wonderful resource and I suspect it will be even more useful as boxsters get older.. Everyone buy a copy!
#18
If you have 5 minutes, can you please put in a review onto Amazon.com?
Thx,
Wayne
Thx,
Wayne
__________________
Your Trusted Source For DIY and Parts
FREE SHIPPING over $99 click here
Porsche Parts | DIY Tech Articles | Facebook | Twitter | Instagram | YouTube | Promos
888.280.7799 | 6am - 5pm PST
FREE SHIPPING over $99 click here
Porsche Parts | DIY Tech Articles | Facebook | Twitter | Instagram | YouTube | Promos
888.280.7799 | 6am - 5pm PST
#20
Just received my copy from amizon last night. This thing is awesome! I've been searching for the "right" Boxster S for a while now and I'll feel a lot more confident making a final decision with this book in hand.
I'll be getting feedback to amizon.com for review. Great job Wayne!
I'll be getting feedback to amizon.com for review. Great job Wayne!
#21
Just received my copy from amizon last night. This thing is awesome! I've been searching for the "right" Boxster S for a while now and I'll feel a lot more confident making a final decision with this book in hand.
I'll be getting feedback to amizon.com for review. Great job Wayne!
I'll be getting feedback to amizon.com for review. Great job Wayne!
-Wayne
#25
Lucky you! Seems the book is selling very well as mine is on back-order and no ETD from Amazon Int'l...
Unfortunately, buying direct through Pelican = int'l shipping fee priced higher than the book itself!
Too bad...
Unfortunately, buying direct through Pelican = int'l shipping fee priced higher than the book itself!
Too bad...
#27
I was just informed by a reader of my book that Project #17 is somewhat unclear with respect to the torque values used to tighten the idler pulleys. I just added this information to the corrections page on http://www.101projects.com/Boxster/corrections.htm :
Page 81, "Replacing Belt Tensioners", the torque values listed for tightening the pulleys require additional clarity. Tighten the pulleys to the following values:
Upper Pulley:
- 34 ft-lb (46 Nm) for the upper bolt if it's an M10x145 (8.8) bolt
- 48 ft-lb (65 Nm) if it's an M10x145 (10.9)
Lower Pulley:
- The lower pulley is tightened to 17 ft-lb (23 Nm) only
-Wayne
Page 81, "Replacing Belt Tensioners", the torque values listed for tightening the pulleys require additional clarity. Tighten the pulleys to the following values:
Upper Pulley:
- 34 ft-lb (46 Nm) for the upper bolt if it's an M10x145 (8.8) bolt
- 48 ft-lb (65 Nm) if it's an M10x145 (10.9)
Lower Pulley:
- The lower pulley is tightened to 17 ft-lb (23 Nm) only
-Wayne
#28