Low Cost Titanium Lug Bolts
#31
Race Director
Join Date: Oct 2004
Location: KC ex pat marooned in NY
Posts: 13,005
Likes: 0
Received 14 Likes
on
14 Posts
They are very nice, I'll post a pic later. I've had the tikore ones in the past, these are just as good imo. I installed with a drop of antiseize and retorqued in 24hrs after a long drive. No issue.
Pic
Pic
Last edited by TT Surgeon; 08-31-2015 at 04:25 PM.
#34
Race Director
Join Date: Oct 2004
Location: KC ex pat marooned in NY
Posts: 13,005
Likes: 0
Received 14 Likes
on
14 Posts
Less unsprung wt, just like a light rim. Realistically, on a street car pure bling, my stockers looked like crap, these look great. New stock lugs from the dealer are pricey, so why not?
Dats all I got!
Dats all I got!
#35
Basic Sponsor
Rennlist
Site Sponsor
Rennlist
Site Sponsor
Thread Starter
Thanks for posting the picture.
__________________
WORLD MOTORSPORTS
2170 W 190th Street Torrance, CA 90504
(310) 533-8900
- Akrapovic - BMC - TechArt - H&R - By Design - AMS - CSF - Kline - NGK - TiLugs - HRE - M Engineering - ID Injectors -
FULL SERVICE INSTALLATION FACILITY - STATE OF THE ART WIND TUNNEL DYNO - ECU TUNING
WORLD-MOTORSPORTS.COM
2170 W 190th Street Torrance, CA 90504
(310) 533-8900
- Akrapovic - BMC - TechArt - H&R - By Design - AMS - CSF - Kline - NGK - TiLugs - HRE - M Engineering - ID Injectors -
FULL SERVICE INSTALLATION FACILITY - STATE OF THE ART WIND TUNNEL DYNO - ECU TUNING
WORLD-MOTORSPORTS.COM
#37
Basic Sponsor
Rennlist
Site Sponsor
Rennlist
Site Sponsor
Thread Starter
I made a lot of lug bolts over the weekend, this is the third run of lug bolts that I have done since starting to sell them.
Thanks for all the orders.
Thanks for all the orders.
#40
Basic Sponsor
Rennlist
Site Sponsor
Rennlist
Site Sponsor
Thread Starter
Yes they do, thank you very much for your purchases.
#42
Rennlist Member
Low Cost Titanium Lug Bolts
Right. I'm sold. Better go prepare myself for the upcoming onslaught of attractive women the lugs I've just ordered are about to bring my way.
#43
Basic Sponsor
Rennlist
Site Sponsor
Rennlist
Site Sponsor
Thread Starter
#44
Racer
Any more thoughts on doing these in extended lengths?
I have 7mm spacers on the front and 15mm on rear so would need 10Xfactory +7mm (37mm thread length)and 10Xfactory+15mm(45mm thread length).
if that can be done I'm in for a set.
I have 7mm spacers on the front and 15mm on rear so would need 10Xfactory +7mm (37mm thread length)and 10Xfactory+15mm(45mm thread length).
if that can be done I'm in for a set.
#45
Basic Sponsor
Rennlist
Site Sponsor
Rennlist
Site Sponsor
Thread Starter
I think that my first longer wheel bolt run is going to be 40mm thread length.