If you have a RSS Series 930 bar in your car and have your rear carpeted shelf properly cut I would love if you could make me a template from your piece so I could cut my piece properly.

If you are in the area I would gladly pick up drinks for your trouble. I would love to meet up with fellow GT3 owners anyway.

RSS did send me their template but I think I would be better off to have one that goes on top of the carpet instead of theirs which positions underneath. It seems like it would be hard to know it is lined up perfect from the underside. With both I am hoping t get it right the first time. LOL

Would also love to hear what you used to cut the holes.

 

What area

 

I am in SE Pa.

Anybody out there have a RSS Series 930? I would really love to get a template made from somebody who has already cut their carper shelf.

 

indifferent of the type of roll bar i found the easiest thing to do is to cut a slit inwards to where the bar is, then install shelf, then you can cut half circles in the slit. the slits look fine since they fold inwards after installation and it looks clean.

 

I have the 930 if that is the beefiest one. I had to remove a bunch of the foam below the carpet piece for it to sit down over shock towers.

 

Would you mind making a template on each side on top of the carpet so I know where to cut the holes?