I'll be there!

...some new pics.

 

The brake ducts are very nicely made. It doesn't look like you had to work them to make them fit.

 

Nice work guys. See you at VIR.

Stephan

 

Can the light block be used to direct some air to the brakes?

 

wow! its going to be a great event at VIR in march

 

hey those look like the factory cup car radiator grilles, are they? how did you fasten them, glue, screws, tiewraps?

 

are those champion RG5's?

 

C14s from CCW

I responded to the PM about the grills too. I can send you some pics. The outside grills are put in using epoxy and the middle grill is screwed in (just use bumperplugs.com to fill the holes if you change your mind down the road)

 

anymore updated pics ?

 

I have fighting the flu this week so I do not have it complete yet but here are a couple of updated pics from last week.

I ended up redoing the Traqmate mount and blank plate.



Here is a not so good shot of the graphics I put on the side. More pics later once I get it done and outside.

 

Can I get some more info on those light blocks/ducts?

Those are pretty cool, and as mentioned above, look like they fit pretty well.

 

so hot. Can't wait to chase it around VIR.

 

question- is it possible to install lightweight inner door panels? where would I get something like that?

 

nice work

Is that FVD Cup Car front lip? Looks v similar to what I m using now...bout 1inch lower but looks v good.

 

I'm installing the cup car front spoiler lip from gmg, not sure if mine comes with the brake ducts or not. hopefully turn-in improves a bit...