PCCM+ Backup Camera Issue
#1
PCCM+ Backup Camera Issue
I recently installed a PCCM+ (Porsche Part #99764259100) in my 2008 997.1. The audio shop added a backup camera using the supplied cable and connector (the car was not originally equipped with a backup camera). The unit works fine but it doesn’t recognize the camera when I shift into reverse. Anyone have a similar experience or know of compatibility problems? Thanks!
Last edited by slevine8311; 04-22-2023 at 05:25 PM.
#2
#4
I recently installed a PCCM+ (Porsche Part #99764259100) in my 2008 997.1. The audio shop added a backup camera using the supplied cable and connector (the car was not originally equipped with a backup camera). The unit works fine but it doesn’t recognize the camera when I shift into reverse. Anyone have a similar experience or know of compatibility problems? Thanks!
#6
for manual cars the cluster has nothing of this sort and has NO electronic signal re which gear the car is in - hence you will need a get the reverse trigger from the reverseLight.
#7
only for pdk/autos as there is an canbus signal from the transmission control unit that tells the gauge cluster (in auto cars) what gear the car is.
for manual cars the cluster has nothing of this sort and has NO electronic signal re which gear the car is in - hence you will need a get the reverse trigger from the reverseLight.
for manual cars the cluster has nothing of this sort and has NO electronic signal re which gear the car is in - hence you will need a get the reverse trigger from the reverseLight.
Trending Topics
The following users liked this post:
myw (04-24-2023)
#10
For my aftermarket rear parking sensors I tapped into the reverse light signal and the reverse light harness in general for all wiring (power + Gnd).
#11
I think its some sort of physical contact mechanism @ the transmission. Which would then feed the black+blue cable in the central harness of the vehicle beside the fuse box (as per main wiring diagram) -> which then feeds both tailLights (also as per main wiring diagram).
#12
only for pdk/autos as there is an canbus signal from the transmission control unit that tells the gauge cluster (in auto cars) what gear the car is.
for manual cars the cluster has nothing of this sort and has NO electronic signal re which gear the car is in - hence you will need a get the reverse trigger from the reverseLight.
for manual cars the cluster has nothing of this sort and has NO electronic signal re which gear the car is in - hence you will need a get the reverse trigger from the reverseLight.
It flips to the rear camera every time the car is put in reverse and you have to give your year/transmission to NM Automotive when ordering.
Below is a note on the installation guide.
The following users liked this post:
Spastblast (01-10-2024)
#13
that is AMAZING! did you do the install yourself?
On my NM Automotive CarPlay/Android Auto unit on my 997.2 manual trans, I never had to splice or tap a wire.
It flips to the rear camera every time the car is put in reverse and you have to give your year/transmission to NM Automotive when ordering.
Below is a note on the installation guide.
It flips to the rear camera every time the car is put in reverse and you have to give your year/transmission to NM Automotive when ordering.
Below is a note on the installation guide.
#14
I recently installed a PCCM+ (Porsche Part #99764259100) in my 2008 997.1. The audio shop added a backup camera using the supplied cable and connector (the car was not originally equipped with a backup camera). The unit works fine but it doesn’t recognize the camera when I shift into reverse. Anyone have a similar experience or know of compatibility problems? Thanks!