New splitter for 996 GT3
#16
Rennlist Member
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
Glad to hear that! Ok so I happen to have a piece of wood flooring that was exactly 3.5 inches wide so I used it as prop and I think that a blade of that width would be good. Oh yes I measured the distance from the wood plank to the floor and there was 3 and 1/2 inches of clearance left based on my car ride hide which is currently 4 inches off the ground measured at the bottom of the bumper in front of the tire.
#17
Instructor
Thread Starter
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
That's great, thanks. So I'm guessing the height at the center of the bumper would be 6". you don't think the 3-1/2 would stick out too far ahead of the bumper?
#18
Rennlist Member
#19
Race Car
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
Could the mounting of the lower to the upper be done underneith with slotted openings allowing for the amount of forward "poke" to be adjustable? Make it to where it could extend up to 3.5" but you could run less if you want?
#20
Instructor
Thread Starter
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
Moving the splitter forward to back would create too many alignment issues and make it a three piece unit. I plan on a flat bottom for this as an option which would also add difficulty to moving it in and out. At some point there needs to be a decission of cost. It could all be done but will it sell if the splitter costs a ridiculous amount because of all the variables.
Last edited by Joe Toth; 05-30-2013 at 10:39 AM. Reason: add a line
#24
Burning Brakes
#26
#27
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
See this. I posted a bunch of photos and my impressions of it. I'm very happy with his 2-piece splitter.
https://rennlist.com/forums/996-gt2-...-splitter.html
https://rennlist.com/forums/996-gt2-...-splitter.html