Notices
996 Forum 1999-2005
Sponsored by:

E-gas, can't hold rpm below 2.4k...

Thread Tools
 
Search this Thread
 
Old 12-15-2008 | 05:35 PM
  #1  
Ahsai's Avatar
Ahsai
Thread Starter
Nordschleife Master
 
Joined: May 2005
Posts: 7,328
Likes: 68
Default E-gas, can't hold rpm below 2.4k...

When you rev your engine in neutral, can you hold any rpm below 2.4k?
Mine ('03 egas) is like whenever I gives some gas, the rpm climbs from 700 to 2.4k steadily and never stops in between no matter how I try. Is that normal?
Old 12-15-2008 | 07:02 PM
  #2  
GaryAZ's Avatar
GaryAZ
Rennlist Member
 
Joined: Jan 2004
Posts: 5,349
Likes: 287
From: Scottsdale, AZ
Default

Yes I can hold 1000 RPM. I know this for a fact because when my MAF was faulty, my car would stall at idle after it warmed up. I had to constantly hold my foot on the accelerator when stopped at a traffic light - tricky business when the brake and clutch need attention too. I figured this skill would be worthless - but now at least i can give you this data point.
Old 12-15-2008 | 08:04 PM
  #3  
Ahsai's Avatar
Ahsai
Thread Starter
Nordschleife Master
 
Joined: May 2005
Posts: 7,328
Likes: 68
Default

Hi Gary,

Thanks. Is yours a egas as well or does it use cable?
Old 12-15-2008 | 11:32 PM
  #4  
sbpsu354's Avatar
sbpsu354
Racer
 
Joined: Jun 2008
Posts: 343
Likes: 1
From: Austin, Texas
Default

I've not done it in neutral, but have done it in gear. Mine's an 03 as well.
Old 12-15-2008 | 11:54 PM
  #5  
redridge's Avatar
redridge
Nordschleife Master
 
Joined: Oct 2006
Posts: 7,446
Likes: 63
Default

is the throttle body/maf clean?

yes I can hold rpm from idle on up...
Old 12-16-2008 | 12:08 AM
  #6  
Ahsai's Avatar
Ahsai
Thread Starter
Nordschleife Master
 
Joined: May 2005
Posts: 7,328
Likes: 68
Default

Originally Posted by sbpsu354
I've not done it in neutral, but have done it in gear. Mine's an 03 as well.
Yes, no problem in gear at all. "Problem" is only during neutral.

Originally Posted by redridge
is the throttle body/maf clean?

yes I can hold rpm from idle on up...
Yes, I cleaned the TB a while back and it was not dirty (car has ~30k miles now). Car drives very well. Is your egas or cable?

Thanks for all the replies!
Old 12-16-2008 | 10:34 AM
  #7  
Loren's Avatar
Loren
Drifting
 
Joined: May 2001
Posts: 2,043
Likes: 3
From: Roseville, CA USA
Default

Only MY99 C2 is non-egas.
Old 12-16-2008 | 10:38 AM
  #8  
redridge's Avatar
redridge
Nordschleife Master
 
Joined: Oct 2006
Posts: 7,446
Likes: 63
Default

Originally Posted by Ahsai
Car drives very well. Is your egas or cable?
yes, e-gas... so, no matter how slight you press the gas pedal, you cant keep the rpm at say 1500rpm in neutral?... what about when the clutch is depressed?
Old 12-16-2008 | 01:54 PM
  #9  
Ahsai's Avatar
Ahsai
Thread Starter
Nordschleife Master
 
Joined: May 2005
Posts: 7,328
Likes: 68
Default

Originally Posted by redridge
yes, e-gas... so, no matter how slight you press the gas pedal, you cant keep the rpm at say 1500rpm in neutral?... what about when the clutch is depressed?
Correct, no matter how slightly I press the gas pedal, I can't hold a steady rpm < 2.4k (I can do that with other cars I have so it's not my foot ). The engine will keep reving up (or down) slowly between 750 (idle) and 2.4k without stopping anywhere in the middle. That's why I think it's weird and worth asking the question here.

Will try clutch in and report back here. Thanks!
Old 12-16-2008 | 02:17 PM
  #10  
Tippy's Avatar
Tippy
Race Car
 
Joined: Aug 2006
Posts: 4,978
Likes: 8
From: San Antonio, TX
Default

Mine did the same.

I chalked it up to a MAF failure but I'm not sure that would be the cause or not. I never tried after I replaced it to hold RPM again.
Old 12-16-2008 | 02:21 PM
  #11  
redridge's Avatar
redridge
Nordschleife Master
 
Joined: Oct 2006
Posts: 7,446
Likes: 63
Default

Originally Posted by Ahsai
Correct, no matter how slightly I press the gas pedal, I can't hold a steady rpm < 2.4k (I can do that with other cars I have so it's not my foot ). The engine will keep reving up (or down) slowly between 750 (idle) and 2.4k without stopping anywhere in the middle. That's why I think it's weird and worth asking the question here.

Will try clutch in and report back here. Thanks!
def not right... Im wondering if the gas pedal potentiometer is dirty or bad... nothing is obstructing (behind) the pedal right?

How about when you drive it?.... can you maintain rpm below 2.4krpm
Old 12-16-2008 | 02:32 PM
  #12  
Ahsai's Avatar
Ahsai
Thread Starter
Nordschleife Master
 
Joined: May 2005
Posts: 7,328
Likes: 68
Default

Originally Posted by Tippy
Mine did the same.

I chalked it up to a MAF failure but I'm not sure that would be the cause or not. I never tried after I replaced it to hold RPM again.
Sorry about the money shift in your sig.

Thanks for the data point. I'm hoping more people will try and see so I can conclude whether this is just the way these cars are or there's something wrong with it. This "problem" does make modulation harder and more conscious than it should be at times (e.g., stop-and-go traffic). I also wonder if it's the MAF but I thought MAF only matters at higher RPMs.

Originally Posted by redridge
def not right... Im wondering if the gas pedal potentiometer is dirty or bad... nothing is obstructing (behind) the pedal right?
I checked and there's nothing obstruting and the potentiometer does feel a tiny bit notchy/sticky but I don't think that's enough to create such behavior.

Thanks.
Old 12-16-2008 | 02:48 PM
  #13  
Tippy's Avatar
Tippy
Race Car
 
Joined: Aug 2006
Posts: 4,978
Likes: 8
From: San Antonio, TX
Default

Originally Posted by Ahsai
Sorry about the money shift in your sig.

Thanks for the data point. I'm hoping more people will try and see so I can conclude whether this is just the way these cars are or there's something wrong with it. This "problem" does make modulation harder and more conscious than it should be at times (e.g., stop-and-go traffic). I also wonder if it's the MAF but I thought MAF only matters at higher RPMs.
Thanks, I am over it.

I remember mine would wander until ~3k and then it would stable.
Old 12-17-2008 | 12:17 AM
  #14  
george996's Avatar
george996
Racer
 
Joined: Jan 2008
Posts: 270
Likes: 1
From: SoCal
Default

my 04 does the same. if you depress the clutch you can control the rpm to any speed.

i would like to know if you notice any vibration at 2000 rpm.
Old 12-17-2008 | 01:15 AM
  #15  
Ahsai's Avatar
Ahsai
Thread Starter
Nordschleife Master
 
Joined: May 2005
Posts: 7,328
Likes: 68
Default

Originally Posted by george996
my 04 does the same. if you depress the clutch you can control the rpm to any speed.

i would like to know if you notice any vibration at 2000 rpm.
Thanks and that's exactly what I suspect (that this is normal). I'll try the clutch in and see. I think I do have a slight vibration @2k as well. Will get back here once the rain stops and I can drive my car again.



Quick Reply: E-gas, can't hold rpm below 2.4k...



All times are GMT -3. The time now is 04:05 AM.