Has anyone done an LS3 swap on here?
#62
Nordschleife Master
I have kicked around the idea of a coyote motor too but i wasnt sure if it would fit in the back of the 911. To be honest i never even searched to see if it had or could be done.
#63
Rennlist Member
I must admit, when I bought my roller an LS swap was my first plan. Then I was contacted by a member with a good 50K mile m96 AT motor and don't regret it one bit.
The broken motor will eventually go to FSI!
The broken motor will eventually go to FSI!
Last edited by 808Bill; 07-12-2019 at 11:47 AM.
#64
Instructor
Moderators, how about a forum session dedicated to LSx powered Porsches. I am looking for information on this and it is out there, but mixed up with other manufacturer.
I think this forum, since it is Porsche everything, should have a session dedicated to this topic.
I think this forum, since it is Porsche everything, should have a session dedicated to this topic.
#66
The heads are huge which give the engine an enormous foot print. I can't imagine it fitting but, like some say, anything is possible.
Mike
#67
Rennlist Member
#68
Drifting
#69
Rennlist Member
#70
Rennlist Member
^^ it's 22,500 euro ($25k) - about the same as a FSI re-build... Uh oh, did I make a mistake...? Nah... !!! I love my 3.8
#71
It would be nice to have a "Swapped Porsche" forum just for this topic. Maybe it would give some relief to the purists that can't resist posting in this thread with their non-LS-related experience in a thread dedicated to LS3 swaps.
Clean LS3 swapped 996 with widebody 997 conversion
Clean LS3 swapped 996 with widebody 997 conversion