Laynego

993 Hifi set please !!! Sending pm.

pplummer

I would like one 993 hifi set please. Sending pm. Thanks!

chaos395

My car uses the HiFi door pockets. Am interested in a set to reinforce.
Please advise.

thanks,

Hank Bernbaum

alibo70

Would like one Hi-Fi set please. PM'd.

Clark W Griswold

I need a hifi set

991-6-3

Hi. I’m interested in the door pocket reinforcements for a 1997 c2s with hifi sound.

Thanks!

Thomas Moore

Good morning. One Hi-Fi set for me, please. PM coming

Zetauno

I would like one 993 hifi set please.
Thanks!
Will send PM

CosmosMoon

Hi Brad,
I’d like to get a HiFi set, please PM me.

thanks,
Chris

993inNC

How much are these? Looks like something I need! HiFi setup as well if there's a difference.

BesideTheBox

All details regarding this DIY can be found in the first post of this thread.

ninjabones

Hifi set please. Much appreciated. Pm sent.

CosmosMoon

Received and installed - they work great! Had some plumbing ABS glue around the house, and it's really easy to work with in this application because the parts fit perfectly. Just want to point out a fitment tip for anyone who (like me) has existing plastic so damaged that you have no idea where the old hole was. There's a tiny lip on the door-handle part that aligns with the ABS of the Hifi cover you are reinforcing. You can measure down from that lip to the hole (in the door handle) with a ruler or caliper to get the height of the hole - it's maybe 3/8" or 8 - 10mm, IIRC. For the left-right position of the hole, it's really important to know where the HiFi panel should fit so that it's snug and so that the lower part lines up well with the flip-up cover. Given the padded nature of the door card, I didn't trust this to a ruler so I put a piece of electrical tape vertically on the door handle so that the edge of the tape half-covered (i.e. centered over) the hole. Then I pushed the HiFi cover into place against the padded door card until I was happy with the fit, and then lightly scored the ABS at the top with a razor in line with the tape-edge, and that gave me the left-right position. Drilled the hole based on this the final fit was perfect! So tight!

EDIT: mm not cm! Thanks BesideTheBox!

BesideTheBox

Thank you CosmosMoon for your feedback.
You may want to edit your post above to indicate 8 - 10 mm, cm is just too big.

993inNC

PM'd you "Beside" and hadn't heard back......