Stephen, that looks great! I love it.
I would like to make a center exhaust, the issue becomes making a bumper cover to work with it.

 

Thats the fabspeed heater box, i am not running full heat on the car, will only be running a hose to one of the headers.....

The cut out is the easy part, its filling the holes left behind is the issue, a friend suggested cutting a larger section out of the bumper and then replacing with perforated aluminum for venting and looks...

 

Nice headers.

Marc

 

The headers are nice, the guy i bought them from is a pain in the a$$


Thanks again Marc..

 

Finally got a bit of a sound Clip.....

http://www.youtube.com/watch?v=mgCWnU4E580

 

The center exhaust is superb!


Andreas

 

Nice pitch, Borla cans?

 

Sweet - how much weight do you think is saved with the centre exhaust setup ?
Difficult to do ?

 

Thank you, once i get the bumper finished it should look even better...

They are not Borla resonators, I will have to check what they are, i'll get back to you...

I can't wait to get a video of them under load.....

From my previous system (which had catbypass pipes) I have saved 25lbs. I also saved an additional 22lb's with the heater pipes and such.

It took about 3 hours in total to build them, the guy I use is amazing at this sort of thing... The hardest part is dealing with the bumper.

 

I think it would look great to trim out the plastic section between the OEM exhaust holes. RWB style. And replacing it with a mesh with cutout for the center.

Something like the pic below.

 

Thats what a friend of mine suggested, some aluminum mesh, right across the back...

Mind you anything RWB looks mean.....

 

Nice! But it looks like your steering wheel is covered in these:

 

They actually sound very good. I find it better than just straight pipes.

 

That sounds very, very nice.

 

Wowow... that sounds awesome. Well done. post a full rear pic once all done please,